Showing code F 20 - Whirlpool Duet GHW9150P Front Load Washer

limited info generic answer u code doesnt show for intex their codes usually start with E this is a manual that has the trouble shooting on page 20 ------- https://www.manua.ls/intex/purespa/manual?p=1 --------- and pg 13 has the codes

Fault Code 092-315: ATC Fail [K] (Black Toner)
https://www.support.xerox.com/en-us/article/en/1244657.html

contact your local dealer about it we have no code list for that brand

Either you are locked out of installer programming or you do not have a Vista 20...this sounds more like a larger panel such as a Vista 40, 50, or some other 4140 based system...verify the model number by opening the main cabinet. The inside cover should have a diagram of the system and the model number. However, since the boards are easily replaced, the cover label is not always accurate. Look at any labels on the printed circuit board to help you properly id the model. By the way, FC indicates Failure to Communicate, meaning the unit tried to call the monitoring center but could not get through (usually 10 attempts) and is unrelated to the "master code". Hope this helps.

Hi I think code 12 is crankshaft position sensor and 20 is Air pressure sensor. Good luck

Read page 4
http://www.rakerappliancerepair.com/NephewClub/Diagnostics/Washers/Fisher_Paykel/F-P%20-%20Bulletins%20-%204-08.pdf

The printer stops working & showed me an error code F-26-1

www.fixya.com/.../t16683015-printer_stops_working_amp_showed_me

Feb 20, 2013 - the printer stops working & showed me an error code F-26-1 , How can I repair it ? I think it s relating to a - Konica Minolta 26NA53040 7130 ...

Konica Minolta 26NA53040... Repair Questions - Fixya

www.fixya.com/.../p4700437-konica_minolta_26na53040_7130_7025_...

Konica Minolta 26NA53040 7130 7025 7020 Oem Lower Fixing Roller Assy New ... Theprinter stops working & showed me an error code F-26-1 , How can I ...

a p1000 code means that the system has not run all checks since last memory erase. in other words after a code erase this code is set until the car has been driven for 2 drive cycles which is 20 to 25 miles then 20 to 25 miles again.

oven door will not close tight - what is wrong

here is a link to a referance of fault codes
http://www.appliancepartspros.com/repairtips/repairtips_appliance+fault+codes.aspx#Hotpoint%20Range%20/%20Stove%20/%20Oven%20Fault%20Codes