A red light is on that idicates that the water tab is turned off where actually is turned on. Any idea???

Is the propane tank actually full? Is the valve turned on? You might want to try a different regulator on it.

power board damaged replace bad capacitor

This is prolly a chevy and that light is just that a low water level indicator it is saying check your cooliant level. Add anti-freeze not water or you may crack your radiator as it gets colder out.

a red light normaly idicates the wrong power i would recomend a new charger.

Hi,

Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

Try cleaning the bottle out with soapy water.

If all 4 bulbs indeed flash then your blinker module should be to blame. It is a plug in module probably next to you fuse box. Unplugs like a wall socket.Pick one up at a salvage yard....Good luck

not a problem aftter inserting the new filter just follow this procedure to reset it..
the indicator light can be reset by holding down on the 'lock' button and the 'water' button simultaneously for three seconds. Sometimes, it is the 'lock' and the 'light' button you need to press down on simultaneously for three seconds in order to reset the filter indicator light.

There is a small tab on the lamp cover that should press into an "L" shaped slot on the lamp housing. This tab may break off, and not press into slot far enough to make the lamp dectection switch click. When the lamp heats up, the plastics expand and the detection switch opens. The projector quits as if no lamp is installed. The fix is to make an extension for the tab. I cut a small piece of sheet metal and crazy-glued it to what was left of the plasic tab.