My DELL Workstation 670 says Memory configuration is invalid and system will halt. What is the solution. It is not detecting menory installed in 1st slot.

Go into your BIOS and see if you have the memory slots active

Change your Bios battery on your motherboard, and because system halted is too general it could be a hardware issue meaning RAM, etc... test your hardware...

glenn_mullin

From what I can tell the Dell Precision Workstation 670 does support over 4GB of RAM. However when you have over 4GB of RAM installed in the system you have to have the Memory Cooling Shroud connected to keep the memory cool. Also this is only shipped out when the system is ordered with over 4GB of RAM originally. If you do not have this part you can order it from Dell buy calling 877-671-3355.

Let me know if you have any more problems or questions

Issken
http://www.fixya.com/users/issken

You need the EXACT speed rated RAM.
Your support page states it needs.....
400-MHz DDR2 SDRAM
NOTE: Your computer supports only registered memory

Memory capacities
256-MB, 512-MB, 1-GB, 2-GB, and 4-GB ECC

256-MB, 512-MB, 1-GB, 2-GB, and 4-GB ECC modules to a max of 16GB
more info here
http://support.dell.com/support/edocs/systems/ws470/en/ug_en/about.htm

I want the workstation (computer) of DELL,
can you help me ? I want the quotation & configuration of DELL Workstation. not a PC ? Please send me.
Thank's
Dev R. Patni

you have a bad memory stick.

You may need to install memory in matching pairs. If the new memory is a single 1Gb module and you didn't already have a similar one they may not work together. Try removing the original module(s) and see if it makes a difference.

Aller sur le site Dell et telecharger les drivers SCSI HostRaid: vous obtenez un fichier qui va creer une disquette, a utiliser pendant l'install de XP (appuyer sur F6 au debut de l'install)

Hey there chandru 2020, the configuration problem which you are experiencing is related to the positioning of your ram in the appropriate slots. Servers work with matching pairs of ram, installed in either two, four or eight sticks of memory. The placement of less than a full set , in your case two minimum is also very specific. You should go to the Dell website to access configuration diagrams for your server model. Also check to ensure your ram is compatible, and try installing just one pair at a time. There is also a possibility that a blank may need to be inserted in empty dimms. I hope this helps. Good Luck!

Support for ISV-certified PCI Express graphics cards up to 150 watts and with up to 512MB graphics memory including: nVIDIA® Quadro® FX 4500;
nVIDIA Quadro FX 3450; Quadro FX 1400; ATI™ FireGL™ V3100; nVIDIA Quadro NVS 280; All graphics cards support dual monitor configurations
All the info for your pc can be found here..... http://www.dell.com/downloads/global/products/precn/en/spec_precn_670_en.pdf