Replacing the contol panel on a Quiet Series 200 Maytag Legacy Series dishwashers. How to? and where to find the part? Thanks

Check the door switch.

their is power to the dishwasher but the control panel does not light up and the machine will not start or run

Hi,

Here is a tip that will help you with how to clean that dishwasher up and get it smelling good again...

Dishwasher Maintenance
heatman101

press the heated button for 3seconds

replace the door latch and the handle check to see if the console loops that hold the latch are broken if so replace the console

Hold down the heated-dry button for 3 seconds and the light will clear.

Sounds like you have a bad Control Board

http://www.partstore.com/Part/Maytag/Maytag/MDB6600AWW/Maytag/Maytag/99003160/New.aspx

But with the price it cost, you might be better off buying a new dishwasher, preferably a different brand, cause that washer has some bad reviews

under the unit where the water line connects,this is where the filters are.disconnect the water line take the fitting off that the line was hooked to,screen is there under fitting.

The dishwasher lights are all blinking, it starts randomly, like one in every 50 times you press the buttons. I have unplugged it to reset several times. Nothing is working. I'm looking for a solution to blinking lights and it not starting. is there any other way to reset the controls????

I had a similar problem where slowly specific buttons stop working. Moisture was getting into the control board and slowly killing buttons. I replaced the control board and that worked for another year, until the buttons began dying again.

For now, there are other ways to start the machine, but you just have to let time expire to stop it. It is probably a control board issue.