I want to know if the WN111 will be compatible to my new WNDR3400 router

Try to find another (friend or other device) power source/cable and test. Usually some other brands are compatible with the cable port.

Sounds like your router is connected to the modem, but the modem is not connected to your ISP. Is this a new connection or a sudden problem? Unplug power to modem and router. Plug in modem first, then router. Do you need password for ISP? If connected, recommend downloading Netgear Genie for your WNDR3400.

my wireless router does its a netgear 71

192.168.1.1

the router may not be designed for that regian you may need to purchase a new router

one way to find out is run this site on the router then run it again without it and see if your speeds change CLICK HERE I use these guys alot.

Hello antonhs2000,

I assume you went through the direct instructions located HERE. It does not suggest a restart anywhere on the page, so I would suggest doing that. I have always made it a habit to restart my computer after uninstalling drivers and installing drivers as well just to be safe.

The NetGear WNDR3400 N600 Wireless Dual takes security very serius and therefore u should read the manual very carefully, giving attention to the pages about the different forms of connections to the router with the different forms of security.
U can access the router as it is described in the amnual, or if not U have to reset and re-initialize all connections with evtually new security settings.
U know, even a router is only a simple com-device, which sometimes hangs and needs to be re-setted.

Good luck
Ganimidis

your problem is simple and applies to most cases. It is lack of technological expertise or lasiness. By that I mean, You did not read the router manual or did not understand it. By default that router comes up in dual band mode. Meaning that it uses 2.4 Ghz for the G and 5 GHz for the N networks. If you want to benefit fully from the WN111 performance in the N mode then you must change the router to operate in a single band mode. (see the manual for the router to see how to do that). (hint: you need to bring up a broswer and type the router's IP address. netgear login standard is: admin and password is password. Go through the router setup and read the extensive explanations for each setup.

have u tryed downloading latest drivers??