Message showing FUSER ERROR??? Please could you tell me what this error is and can it be fixed?? Thanks Suze

there is nothing to look for it told you it is past the end of it's life so buy a new unit

Disassemble fuser and inspect thermistor and heat lamp. Then replace broken part.

it error code means fuser unite problem please change fuser unite then solve your problem

The error is Fuser cam position not found. Have you tried reseating the fuser? Does the fuser make any loud sounds? Based on the error message, it could either be the fuser, or the system board.

From HP Website:
50.X FUSER ERROR Description A fuser error has occurred. Action

1. Turn the printer off.
2. Verify the fuser is properly installed and fully seated.
3. Turn on the printer.
4. If the message persists, contact HP Support.

Your fuser is not warming up. You will need a technician to look at it.

It's the fuser. You can try turning it off, wait 30 seconds, and turn it back on again.

If the problem continues, call a technician in to get the thermistor replaced.

It's a common error.

My HP Color Laserjet 2600n Printer is giving me error as

" 50.2 Fuser error " . then every time i have to reatart my printer.
please give me suggestion.

thanks and regards.

ajinmumbai

Try this,

Reset Fuser Life

1. Using the control panel buttons scroll to Maintenance, press OK.
   
2. Scroll to Check Others, press OK.
   
3. Scroll to Fuser, press Reset

E000001-0002 refers to the fuser assy either getting to hot or not hot enough. Fuser error codes cannot be reset by power cycling the machine even though that is what the display tells you to do. In order to reset the fuser error code you must enter the service mode & reset the code. To enter the service mode: press"Additional Functions" button (looks like a picture of a head with a star inside) press the #2 and #8 at the same time (simultaneousley) press "additional functions" again The display should show a choice of copier,feeder,sorter,fax,or board service modes Select copier select clear select ERR press OK Turn power off & back on. ****IMPORTANT**** After clearing error stay at the machine to see if it comes to ready. The fuser assy can reach 139 degrees C.(Water boils @ 100C) The error can only be cleared through the service mode because a technician should inspect the fuser to verify there is nothing faulty that could possibly start a fire. If you enter the service mode & clear the error, power cycle the machine & during warm up the machine throws a code again- turn it off, unplug it & call a tech for fuser repair. Good Luck!! I can be reached @ [email protected] if you have any questions.