My amp will not turn on i think its burnt how would i fix that

I think you got it figured out

Burnt clutches & your done,
time to rebuild, there is no other option

Some friends he has that believe a filter
has anything to with anything

Some people actually believe changing fluid
fixes things,others, mostly on this site change fuses
& relays & all sorts of parts in a wish & hope theory

You should read the questions on here & see how
uneducated people are,sad,stupid & silly just to read
the stuff on here

$2,500 may be a little high

Could be 100 things. Do you see any burnt components or burnt spots on the board? Probably no way for you to fix this unless you have the electronics repair skills unless you visually spot a short on the board like a loose screw that ended up laying on a couple of components etc.

you have fitted a single pole bulb into a two pole socket ,have a good look at the end of the bulb and the look inside socket and you will see what i mean

yes search amp repair in ohio

ok, have you checked for power at the power point? if you have power to the machine and the display doesn't light up after you have turned the power point on then your control module is faulty. only the phase 5 models don't power up if the pump is faulty, your machine is a phase 2 with a blue control module. by the way, what part of the machine did you pull apart? i think your pump was faulty which made the control module faulty. check the pump for a burning smell. if it is burnt then i"m sure your module is too. please reply if you need more help to fix this problem.please turn off the power b4 you work on it, don"t want any accidents . good luck.

contact Eric @ Capital Audio & Electronics Repair in Tallahassee,Fl we repair all namebrands & models

it maybe fixable. the problem is that when you find what is burnt or messed up, you replace it. after that you need to find out why it burnt or messed up. i wouldnt recomend trying to fix it your self unless you wanna chance it. but if you take it to a technician that can fix it the will be able to tell you if it can be repaired. also check your power and ground wires. make sure youre getting 12 volts to the amp. check your subs and make sure they are good. a bad sub will put a amp into protect. good luck.

in and out probaly 2 thinks bad or low fluid
or a burnt tranny
eithor way it's aamco time b4 it fries the hole trans

REPLACE THE WIRE MAKE SURE IT DOSE NOT RUB AGAIN REPLACE FUSE IF THAT DOSE NOT WORK SOME COMPONENTS MAY HAVE BURNT UP HAD TO SAY WITH OUT LOOKING AT IT TAKE THE COVER OFF SEE HOW BAD IT IS GOOD LUCK

Heat sink is jacked!!! Burned it out. Replace it or send it away to get fixed.... check the pricin on it sometimes cost alot almost as much as new amp....