LED light goes red (not blinking, just stays red) and none of the buttons on the lock work.
My reply:
I have reviewed the installation instructions for the Kwikset 907-11P; here is a link to it:
http://s7d5.scene7.com/is/content/BDHHI/40486-02
Under normal circumstances there is no need to reprogram the lock codes when batteries are changed.
On page 9 of the installation instructions is Troubleshooting tips and a contact number for Kwikset USA :
1-800-327-5625. I'd recommend calling them directly if, after going through the installation instructions, that you have the same problem.
Good luck--and please provide feedback if this helps!
If the blinking light is on Toner Low, press and release the Continue button (green button) to clear the light sequence and continue processing the print job. If the light is still blinking, the photoconductor is almost full and should be replaced.
Diagnosis: If none of the above test resolve the issue, then the failure lies in one of the following:
474 views
Usually answered in minutes!
×