Olympic InfoGlove Blue

Posting this under communications equipment, rather than Cameras, is more likely to get a response

Call and make sure the caller ID function is still active with your phone service provider.

I am having the same issue... Except mine started a few days ago and I wasn't due to refill until today.. I don't know what to do either. Tried calling straight talk and was on hold forever

You need to reset the menu once again as it is possible that the phone had hung up as there was LINE PROBLEMS . Once this was reset the CLIP facility came back. So if you can once again remove power battery and keep aside to reset , then start all over to set up the base and slave units to MESH , the intercom and line facility must work.
You can remove the battery from the slave remote units to reset.

caller id not working

I had the same problem - until today. Seems that the phone jack wiring in my living room needs repairing. Receiving and making calls is no problem, but the Caller ID is first to go (according to phone service provider). I tried out the phone in the bedroom, and the Caller ID shows up fine. Serviceman coming tomorrow to fix the L/R wiring.

Don't mind. Returned the product to the seller. Thanks.

battery weak change ur battery

Even at its factory defaults your Siemens handset should be showing the caller id after the second ring. Look at your time and date on the phone, if they are not accurate then the caller id signal is not coming through since when activated caller id will not only give you the caller information, but it syncs with the telephone companys clock too. If I were there, I would take a phone that is known to have its caller id working and plug it in your line and see if caller id shows up on it. If it does show caller id, then there is something wrong with your Siemens base. If it does not, then your phone company dropped the ball and caller id is not activated. Then I would take the Siemens phone to another line (neighbor or friend) that has working caller id and plug my Siemens into it and see if it shows up. Doing all that will isolate your problem, I guarantee it.