We have a router motorola WSAP-5110-100-WWR ,, But don't have Antena,, What to do to connect ??

Try separating them further apart;they are all sharing the same source.Moving just an inch,at any distance,can make or break a signal strength.

router automatically detect the modem when you insert the UTP cable in the UTP port that's easy. But if you want more pc to be interconnected and the port of the router is not enough to interconnect more pc, laptop or any device...you need to buy hub to bridge them all...
Don't worry no configuration being done. Just connect cables and it will be detected automatically

Hi,
Welcome to Fixya. I would like to know the location of the wireless router and the wireless computer and the google tv. Are they in a same room, same floor? any walls or obstacles that can block the wireless signal? any other device that has the same issue with the router when put in a same room? Please provide the information needed to be able to fix the issue.
Thanks

go to this ip
http//:192.168.100.1

Defualt login: (if you did not set one)
user: admin
pass: motorola

and you will get the con-fig for the router

also here is the manual for this router/modem.
MotoModem

Any wireless router should be compatible with your modem.Some are as easy to set up as only plugging the cables in the right jacks and you are done.

Just make sure your Motorola is configured to stay connected 24/7, and instead of plugging it to your computer, plug it to the router. Generally, the routers don't need to be configured.

From the installation guide for this AP, I find the following:

LED Indicators

The unit has LED activity indicators on the front of the case provide a status display indicating error conditions, transmission, and network activity for the 802.11a (amber) radio or the 802.11b/g (green) radio.

802.11a Activity LED Amber

The amber LED flashes three times per second until firmware is loaded. During boot, 802.11a mobiles cannot associate. After adoption, the amber LED is steady or flashes with 802.11a radio traffic.

The amber LED flashes once per second if an error prevents the 802.11a radio from operating normally.

802.11b/g Activity LED Green

The green LED flashes three times per second until firmware is loaded. During boot, 802.11b/g mobiles cannot associate. After adoption, the green LED is steady or flashes with 802.11b/g radio traffic.

The green LED flashes once per second if an error prevents the 802.11b/g radio from operating normally.

From this, it appears that the 802.11A radio is malfunctioning.

Here is the Motorola support web page for this device.

ckeck on table top (Router and Laptop / PC both one same table) and if you still getting poor signal then please check your router's antena proper connected or not.

Hi,
Wireless routers were configured with some security PIN in order to avoid unauthorized connections to your router. To connect to your router, just providing the PIN will do and no need of complex settings. Contact the service engineer who configured your router last time and tell him to configure your router with whatever preference you need. you can also set it in public mode so it wont ask anything and so anyone can connect into your router but this is not secure at all.
I hope this is helpful to you.
Thanks

I don't recall if that phone had an external antena but you should check if it is well mounted,if it is not dammaged,rusty and if it had an internal one check for no oily stuff inside. If the antena is not the problem try contacting your operator and ask them if they suport such conectivity since direct satelite connection is expensive!

To whom it may concern.
My wife found it , on edge of carpet. How it got there i'll never know.

Thank you

A. Firth.