Same problem as above.Disney p1310ATV lost the remote. No Phone # in orginial manual.Television system NTSC (American TV Standard) I have tried other universal remotes also I have a Sony RM-V210 universal remote that will work the sound and change the channels but nothing else. The numbers will not change channels. I am trying to change the input so I don't have to listen to the same movie 120 times. My neighbor has a similar Disney 13" TV but their remote will not work on this TV. Thanks Shane

I used the vibe 4 in one but with Emerson codes1008

If you need owner manuals GOOGLE each model number with manual to locate them.

Try setting it to cable remote--see manual or check back label for manufacturer's parts and accessories phone number.

Look on the back of the TV or in the back of the manual and you'll see the name of the company that manufactured and/or distributed the TV, or you may find a telephone number listed in the manual. You must contact the manufacturer to find a replacement remote for that TV. Universal remotes don't work because that set is actually made by a small company that doesn't communicate with universal remote makers.

I hope I've provided you useful assistance and that this information allows you to make an informed decision as to how to proceed from here. Please be sure to vote on my response. I hope I've earned a good rating from you today.

Please post a comment if you need additional assistance so that I can help you further.

My disney princess tv model P1310ATV uses code 759 with Echostar 6.2 and 6.3 remotes. This code is listed in the echostar manuals as a code for Hisense manufactured TV's.

On your dish remote, press and hold the tv button until all 4 buttons light up, then release. push either of the power buttons once. Now start pushing the down channel button, It's the one right below select, continue pushing it until tv turns off. When tv goes off push down button one more time then push up button, when tv turns back on stop and press # key, tv light will flash 3 times and should be set. Note....if u press down button and tv does not turn off after going through all codes( tv light will start flashing) press cancel and try again only channel up this time. hope this helps.

if you know how solder.then re solder your tv first. then,check the vertical section maybe the ic is busted

It tells you how in this manual.....http://www.ipc.nl/extensions/templates/default/gebruikshandleidingen/en/TV_combis/Pirates/10202_TV_PIRATES_GB_GA.pdf

I too own the Disney Pirates of the Carribean television. We have it setup in my boys' room so they can only watch DVD's, there is no cable connected to it. However, everytime we turn it on, we have to use the remote to change the input to dvd. The large Mickey button on the remote fell out and my daughter lost it. Without that button, you can't change the input at all. Therefore we have a perfectly functioning television that we can't use.

I emailed Disney and they redirected me to the actual manufacturer of the TV, Starlight Griffin. The phone number is 866-387-1902. I called and within 5 minutes, I was told that I would recieve my new remote within 10 days at NO COST TO ME!!

I went crazy for days trying to figure this out so I had to share that info with all of you immidiately! Good Luck!!

I used Memorex code 135