Just install it. No jumpers are needed on a SATA drive.
SOURCE: How to make sata hard disk a slave???
Look at the jumper settings. These jumpers are located near the data cable and the power port of the hard disk. Usually by default, this jumper is set to "Master". To make it a slave, just remove the black or blue jumper or please refer to the jumper guide table printed in you hard disk's label.
SOURCE: Problem with SATA WD Caviar SE WD2500AAJS hard drive model
hey there
there are tiny little jumpers on the hard drive itself there's also a diagram that tells you what jumper to set..basically there's only about 3 options try the other two options then plug it on the mobo and then try to see if the mobo detect it.
one of the option WILL always work.
good luck
smeags
SOURCE: Western Digital Caviar SE WD800JD SATA Hard
Yes it looks like a Hard drive problem.
This error means that NTLDR is missing somehow from your computer,hard disk problem usually or virus.
You can go to that page and follow the instructions exactly as he says and will not have to install windows over and over again
http://www.tinyempire.com/notes/ntldrismissing.htm
The BIOS is AMI. Under ADVANCED SETUP:
The options listed for 1st,2nd ,3rd Boot device include:
IDE-0 means Pri master ?
IDE-1 means Pri slave ?
IDE-2 means Sec master ?
IDE-3 means Sec slave ?
?
The BIOS is AMI. Under ADVANCED SETUP:
The options listed for 1st,2nd ,3rd Boot device include:
IDE-0 means Pri master ?
IDE-1 means Pri slave ?
IDE-2 means Sec master ?
IDE-3 means Sec slave ?
?
? single or master :::::
master with slave ::'::
???????????????? slave? :::':
note the plastic jumper is ' located at the rear of the hard drive next to the IDE/SATA lead/s
?
hope this helps
?
?
?
hope this helps
1,017 views
Usually answered in minutes!
×