NOT CLEANING CUPS & GLASSES FROM INSIDE...HOW TO TAKE APART THE WATER SPRYNCLER.

that will happen if the drying cycle isn't operating properly. also happens if cups and glasses have large depression on the bottom (when upside down)..... try putting them in and setting at an angle, not straight up/down.

It sounds like you need to check the filters and clean them. It’s usually pretty simple to do but makes the dishwasher run like new. I think that it might be obstructed somewhere preventing it from being able to fully rinse the dishes. Is it draining all the water after the cycle has finished?

You need to add some vinegar. Depending on your water as much as 4-5 cups per load. I have had a Potscrubber for close to 10 years and discovered that they clean beautifully as long as you don't skip the vinegar.

INSPECT WATER INLET FILTERS ANS SALT COMPARTAMENT

Check the spray arms are not clogged as well as the top one take off the bottom one clear a hole underneath the arm. make sure the arms can turn freely. dishwasher fresheners hanging on the basket can stop the arm turning. clean the filter in the bottom. Is the machine heating it should be hot at the prog end.

You should try cleaning all the filters inside,take them all out & clean them well.Also remove the wash arms & make sure there is no food scraps blocking any of the water holes in them.After doing that you should run some rinse aid or dishwasher cleaner thru a cycle.

Refer user guide. They would have given clear instructions regarding cleaning.

If you are finding it difficult pour sufficient water in the wash chamber. When the particles float remove them manually using a small cup.

It's little bit tough exercise!!

There may be debris in the pump that needs cleaned out. I have put together some instructions on how to clean it out on this model if you care to try it out. It takes a bit of technical understand but it is not too difficult.

Let me know if it helps you out.

poor_cleaning_or_noisy_pump_KitchenAId

If there is not enough water, the dishes will not get cleaned. This could be caused by a partially closed water shut-off valve (located under the sink), or a faulty dishwasher water valve (located at the bottom of the dishwasher, behind the kick panel, on either side).

Also, There is usually two, sometimes three spray arms in a dishwasher. Make sure there is no debris blocking the holes inside each spray arm.

**Water temperature Note***

To get the best results, the water has to be at 120 degrees Fahrenheit when entering the dishwasher.

Concerning the Film, or cloudy look after the wash cycle.

This problem occurs due to excessive calcium build up inside the dishwasher. Try cleaning you dishwasher using a dishwasher cleaner. There are a few out there, Try Dishwasher Magic.

they must have changed the way they treat the water in your area. those spots are caused by hard water. www.dishwasherfilter.com has a product out for this problem. it filters the water going into your dishwasher leaving them spot free and crystal clear with every load. you will love the way your dishes look.