My air hogs switchblade's controler keeps turning off while its charging whats wrong?

Blinking red means the Switchblade hasn't sync'd to the remote.

For almost all R/C you need to follow a specific sequence, whether its:

Remote on, vehicle on, (wiggle stick on remote).
Vehicle on, remote on, (wiggle stick)

There's usually an additional process for a vehicle that has built in gyros, etc.

Ya air hogs hawk eye

Make sure you have the switches set properly.

Amazon.com has a demonstration video- it launches from the ground or from your hand- just set it down and turn it on.

Make sure that the switch on the helicopter is on charge (CHGE).

Did you turn the actual helicopter OFF? make sure that is switched OFF. Did that help?

air hog hawk eye helicopter keeps cutting out when fully charged for no reason

1.Take out charging wires. 2.turn off your heli and insert charging socket into your heli's socket. 3.the charging green light will light up while charging. 4.charging complete, the green light will turn off. 5.pull out the wires and you are ready to fly. Let the heli's battery cool down for approx. 15 minutes before charging.

As far as the green light on the charger not coming on: after I tested the batteries in the remote, I found that it was due to 2 of the 6 batteries in the remote control being dead (0.1volts) The charger probably sucks the power out of the #1 and #6 battery.

Make sure all batteries in the Remote have the same charge.

Also, there seems to be a loose contact in the charger plug prongs. You will have to find a way to sit the helicopter so that it stays in contact with the prongs while charging. Mine has to be on it's side to keep the green charger light on.

Good luck!