Problem 9-357 code

Good Afternoon Paolo, thanks for your post!

I see that you need to reset your Electrolux dishwasher due to replacing relay and an error code. The best way to reset your dishwasher is to disconnect power from it for roughly ten minutes. I hope that this information is helpful to you. -Matt

Hi especially you will get this error-9-357, if the Black Toner Dispenser Broken.

The answer I found seems unlikely but please give this a try:
Solutions for : Black Toner Empty Message Related Fault Codes: 9-274, 9-357, 9-368, 9-400, 9-453

Solutions ranked by relevance:

1. Replace the Toner (Dry Ink) Cartridge
2. Power OFF, Wait 30 Seconds, Then Power ON

To investigate further please see this website:

http://www.support.xerox.com/support/docucolor-12/support/enus.html?operatingSystem=winxp&fileLanguage=en&&associatedProduct=fiery-ex12


Trust this is helpful. PLease vote to show your appreciation. :)

9-357 system fault

357 ASF paper feed (AP) position error
Cause: An error occurs at the AP positioning in the ASF (Auto Sheet Feeder) unit.
Solution: (1) To reboot, press [OK] button or turn off and then on the power.
(2) Replace the SHEET FEED ***'Y.
(3) Replace the SPCNT board.

Hi,
The error 9-357 normally refers to a toner issue.
This normally refers to a color/Black toner problem. Probably there is low toner sensor defect.
Check for the ink in the cartridges as well but before that try to vacuum and clean the toner dispenser. You must vacuum whole path which is used to transport the toner to developer unit.

9-357 Black Toner Dispenser Broken.

Don't have the codes for that one BUT 09 --- codes always refer to drum/toner problems. Make sure the drum unit is plugged in properly, and cables/plugs etc secure

9-357.
Black toner problem.Probably You have low toner sensor defect.
But try first to vacuum and clean black toner dispenser.You must vacuum whole path wich is used to transport black toner to developer unit.Then if printing B/W print only, you must print 10 full color sheets every 100 copies.

Try Canon Technical Support-maybe a defective printer to be replaced with a recon unit. failing that try www.fixyourownprinter.com