Re: Hi, we haven't got a manual for our Westinghouse...
Press hold in for few seconds if not get unlocked you have to get new on and of switch due to this dishwasher switch burns out its popular with this dishwashers power switch burns out
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hello Cathy I have fixed many appliances by using the
RepairClinic web site. Normally the hot water is boosted to 180 F
to sanitize the dishes. The incoming hot water supply could be around 120 F. Perhaps the heating element needs replacing. Have you looked at the Westinghouse web site ?
Ken
1. Is your drain point higher than the bottom of the dishwasher? (ie, does it drain into the garbage disposer or does the drain line drop down below the floor into house plumbing?) Did you just install the unit? You may have to install an "air gap" to prevent syphoning.
2. Did the dishwasher work then suddenly stop working? (asking for clarification)
found the 2 large lugs mounted on the circuit board had been hot and had dry solder joint's removed solder cleaned with sand paper then re soldered and tested it now heats up .
Westinghouse SB907 had same problem, which I had thought might be the heating element. Fixed relay soldering on PCB where it was burnt/melted, now works! This probably applies to the Westinghouse SB925 also.
hi check the lineament of the dishwasher door if the dish washer is not level front to back and side to side it will be lop sided and the door seal may not be depressed enough and may leek from the bottom part of the door seal too ways of checking this is to run a level inside the unit side walls and a small level for side to side leveling the other is to just close the door and at the same time checking the inner chrome part of the door with the inner side walls as they should not clash nor be closer to one side than the other i hope this helps as it is hard to explain
×