Cant find potentiometer screw to adjust for counter clockwise over rotation on my iwave dragonfly helicopter

Counter clockwise 3 full turns then clockwise to the first number.

http://www.gwsus.com/english/product/airfly/dragonfly.htm

The best place to get parts for your heli.

Good Luck

There are adjustment screws on the rockets according to RAVE.
The procedure is as follows:
1) Rotate the engine clockwise until No 1 injector lobe is at full lift.
2) Rotate rocker adjusting screw clockwise until the injector plunger is felt to bottom out.
3) Rotate rocket adjusting screw anti-clockwise one complete turn to give plunger the required bump clearance and tighten rocker arm adjusting screw locknut to 16Nm. Ensure the screw does not turn as the locknut is tightened.
4) Carry out the procedure for the remaining 4 rocker arms.
5) After completion of rocker arm adjustment slowly rotate engine clockwise 2 complete turns by hand to ensure that no injectors are bottoming out on their plungers.

lost instrutions for dragon fly rc helicoptor

Swap over the two wires that go from the motor to the speed controller. NB. don't swap over the wires at the battery this will destroy the speed controller.

You can adjust the trim under the stick on the transmitter and/or the trim screw on the helicopter. If this is still not enough the motors will need to replaced so power matches.

Syma DragonFly 9093 or 9083 rc heli... has the same exact size tail blade... just put one on myself... works fine..

usually trim adjustments are on the controller... not on the vehicle itself.
a potentiometer os a fancy word for dial adjustment. It wont be a metal screw, but probably a metal square with a plastic looking slot that can be turned. usually white or blue plastic

Unscrew the crown, pull out the crown fully to the second position. and rotate the crown counter clockwise or clockwise. Push the crown back in and screw down the crown.

You should not have to adjust this clutch head screw. And it turns counter clockwise to change the time of defrost.