I purchased the S006G Syma helicopter for my son on christmas. I have charged the helicopter and installed new batteries in remote. Everything lights up. The radio light blinks yellow and it does not operate the helicopter. All lights on helicopter are lit up.
Any ideas?
Thank you
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Is the "flight light" blinking on the copter? If you connect the USB cable to the copter will it power up? Have you tried different batteries in the remote? Check the pins in the charging port on the copter, Otherwise there's not a lot that can be done with these little RCs.
did you charge the helicopter.... you need to put the charging cable in to the copter. and charge up can use a usb power plug. when charged the light on the usb cable should light up or flash. also if you take the plastic cover off the front there is a battery in there and a board check to see what number its set on. it takes around 5 seconds for the remote to recognise the unit.
0) Obviously, helicopter will operate best when fully charged... if
charging light gets brighter when unplugged from helicopter, then it's
not at full charge. Charge fully, then allow battery to cool for 10
minutes. Good batteries in remote also. 1) Power on helicopter. 2)
Place on level surface and let gyroscopes sync. There is a red light
inside the body (NOT the red/blue flasher in the nose) that will blink
when you turn helicopter on, and will keep blinking until craft is level
and stable for a few seconds, then will stop blinking. 3) Make sure left joystick is all the way down. 4) Power on remote. 5) Throttle up (left joystick) until blades move and then all the way back down. This should get you flying. Let me know r
0) Obviously, helicopter will operate best when fully charged... if
charging light gets brighter when unplugged from helicopter, then it's
not at full charge. Charge fully, then allow battery to cool for 10
minutes. Good batteries in remote also. 1) Power on helicopter. 2)
Place on level surface and let gyroscopes sync. There is a red light
inside the body (NOT the red/blue flasher in the nose) that will blink
when you turn helicopter on, and will keep blinking until craft is level
and stable for a few seconds, then will stop blinking. 3) Make sure left joystick is all the way down. 4) Power on remote. 5) Throttle up (left joystick) until blades move and then all the way back down. This should get you flying. Let me know.
The problem is the battery, I just got one for Christmas and overcharged the battery. I put a new one in and it works. The manual says never charge over 90 minutes.
×