I began a wash on a Bosch WOL2200 top loading machine and it began to make scraping noises as the drum turned. I opened the door once it was done and now i cannot get my clothes out! The drum wont turn by hand! I was able to retrieve a sock from in between the drum and the outer wall. Any ideas on how to unjam?

I assume that the damage was done with the clip and so the excess pressure on full load caused the leak. Now you need to check from the door seals which could be damaged. If the leak is seen only with a load then it can also be from a top leak in the drum . In all cases using a good light you must be able to check for damage on the drum or the seal.
Check this link for tips: door seal

Hi from retired Englishman in SW France @ 17:09 Mon afternoon.

Manuals can normally be sourced from the web.
Type into your search engine 'bosch manual' and you should be given a number of places to try, asking you for the particular model at some time or another! You could try 'bosch wol2200' from the start!

Good luck,
John C

If you are the fix-it-yourself type you can take the screws out of the front panel and top panel ( if the door is locked there is a green cord hanging inside the round port on the bottom of the front panel, find it and pull it to open the door) then take the two screws out that hold the switch and unplug the 3 modular plugs on the switch.
The switch comes apart by carefully un-clipping the brown clips around its edge. Take note of the assembly inside so you can put it back together properly. The little armature that goes through the magneto sometimes slips out of the groove where it ends with a small flat head. once everything is in place clip the switch back together and install the plugs and the switch.Replace the panels and screws and you should be back to normal. Do this if other remedies fail.
C.Dominici

open the filter door bottom r/h side remove the filter and any blockage/ coin within

This video will show you how to change a door seal on this Bosch WFMC 2100UC front loader washing machine
we have all bosch repairs in our channel
You can get seals on eBay

I have never cleaned my washer as i use bleach in with the whites when i wash. its up to you. they do make a cleaner for that.

This is usually too much detergent or severely out of balance load. Unplug the washer, this will allow you to open the door to re-balance or eliminate very heavy items from the drum. Close door re-plug and restart machine. If this doesn't do the trick repeat the unplug and reset the dial to rinse/spin to clear excess detergent once finished restart normal wash cycle.

possible something has gotten through the tub "holes" inbetween the drum and the tub

I have a Bosch wol 220 washer, it is not clearing the water on spin. I have checked for blockages and it appears clears.

more likely there is a bra wire caught between the inner drum and outer tub, possibly wrapping itself around the element in the bottom.