Camera says "Please e-operate after pushing reset

If the shutter has 100K operations then the camera may be due for a replacement (not worth repairing).

Please make sure you have a fully changed battery in the camera. If the camera does not have a battery icon anywhere showing a low or dead battery then you have a camera that should be sent to a Nikon Authorized service center. They can clean and repair your camera. They will; QUOTE the repair before you pay. All you are out is shipping costs.

nocko pradika try to do factory reset by settings, it will solve your problem, if problem persist post comments for further help, if my answer was helpful please rate it, and Thanks for visiting Fixya.com. Best of Luck.

This is just a wild guess, you understand, but maybe it could be fixed by getting it serviced ?

Find the flash memory card that plugs into your camera and stores the pictures. It's usually behind a door or flap on the side or bottom. Remove the card, usually accomplished by pushing it in and then it should spring outward slightly -- at least enough for you to pull it out the rest of the way. Check the card for a tiny sliding tab on the side and move it to the opposite end of its travel. See this wikipedia article for pictures and more info about write-protection.

Just push the "reset" button and try again. The reset button is next to the EJECT button. You will need something small to push it in.

G'day,

I also have the same problem and after almost buying a replacement I thought I would try one time to get it to go.

What I did was start the cam without a tape in it, let it bring up the little red icon indicating no tape inserted, (it hadn't started flashing "PLEASE RE-OPERATE AFTER PUSHING RESET BUTTON" at this stage) then I inserted my tape. Hey presto, it works although for how long I don't know. I'll immediately start burn my tapes to disc while the going is good.

Hope this helps someone

This means you need to get it serviced, because it has detected a fault or error.

send it in for service... sorry

Hi,

Could you please provide more details such as Camcorder model and company? Thanks.