At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: We have a problem with copier ir 5000 troble E 061...
Enter service mode( * 28 * >copier>option>PO_cont> off> ok) and make copies if erroir code does not display, replace potential sensor.check dc controller.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
C0400 -Exposure lamp failure to turn ON C0410 -Exposure lamp turning on at abnormal timing Turn OFF the copier,remove the glass,Work a screwdriver trough the hole in the frame at the left front side of the copier and remove the screw that secures the scanner unit.Move the scanner to rhe right hand side of the copier.Remove 3 screws to free the scanner.(To remove the scanner turn it counterclockwise).Remove 1 screw and the wire guide,remove 1 screw and the ground wire.Unplug the exposure lamp terminal connector,unplug the thermal fuse connector.Remove the scanner from the copier.Verify the continuity of the exposure lamp and thermal fuser.If is defective change.
Hi check that the exposure lamp is coming on place a sheet on the glass press start and see if the exposure lamp comes on and stays on as it copies if it does not come on then you need to check the lamp and the scanner cable for the lamp
if this dose not resolve your issue check the main charge on the drum check the corona wires are intact
The above will resolve your issue
this is an issue with ae sensor board pwbh board
what you will need to do is check the voltage across pwb-a pj3a-3 and ground dc0.18v or less when the scanner is at the home position the exposure lamp is off and the original cover is lowered
if yes change pwb-h if no change pwb-a
the code 803is for faulty exposure lamp or fault in composite power supply(the power supply to exposure lamp is not sufficiant to operate the lamp).to remove exposure lamp, remove copyboard glass,remove back cover ,slide scanner in the line of rear exahaust fan at the right side of scanner, remove rear exahaust fan, remove lamp holder(one screw).slide out lamp on the rear side replace new one and reverse the whole process.
×