Hi I need a new bar for the model # S 1637 sharper image quadra.

Joyce, according to Sharper Image, if you purchased it online from Sharper Image after 2008, they will assist you with the repair. Call Customer Service 877-714-7444 . If that is not the case, you can either return it to the place of purchase for repair or take it to a small appliance repair shop,

Hi.

This appliance simply resets by disconnecting the power cord for five minutes. The control board does not include battery.


If the model was manufactured before 2007, pleas read below.


Ionic Breeze Concerns


Regards.

Ginko.

The trouble began in 2003 when Consumer Reports magazine published a report claiming the expensive air cleaners don't clean air. The magazine later claimed its tests showed that Sharper Image's Ionic Breeze Quadra Silent Air Purifier and four other units also release potentially unhealthy levels of ozone.


Read more: http://www.consumeraffairs.com/news04/2008/02/sharper_image.html#ixzz0VATFAuRq
?

http://www.consumerreports.org/cro/home-garden/news/2007/02/settlement-in-sharper-image-ionic-breeze-class-action-2-07/overview/0702_sharper-image.htm?Extkey=SY95PI0&CMP=KNC-CROVMYSSP&HBX_OU=51&PK=yssp

ebay item number:220444965077

Under $11 and shipping is $5. Easy to replace and if you require instruction just reply to this post.

There's a link to one manual here:
http://www.amazon.com/Sharper-Image-Breeze%C2%AE-Purifier-SI637BLK/dp/B0000AUTU3

try google

one of the electrodes broke off the botto of one of my towers.

Hi,
Please check following web info might helpful / interesting for you.

http://www.fixya.com/support/t1065831-contacts_in_ionic_breeze_contacts

Sharper Image products are no longer supported since the have been recalled after being prov-en to be ineffective

Here is a link about the Chapter 11

Here is an EPA link about them

Have you cleaned the bars lately? I believe that red light means that the bars that collect the junk from the air are at capacity and needed to be wiped down.

If you don't know how to do this, pull them out from the top after having turned the machine off. Get a rag or paper town moist, but not dripping and just wipe the black soot off all visible sides of the metal bars. Lay it aside when done over night for it to dry completely, then re-insert them into the machine. Turn on and hopefully that should take care of it!