A sheet of paper had remain in the cylinder - HP PSC 1610 All-In-One InkJet Printer

Its common problem in T Series Plotters:
Cause of malfunction: These plotters having separate sheet path as well as roll path for print media. After initializing plotter its verify the available media(sheet or roll). If sheet path is occupied by the media it wont allow the roll media, means first priority is for sheet.If sheet path paper sensor dusty or malfunction, printer will say "remove paper from sheet path" even no paper in sheet path..
How to shoot this problem:
You need to clean sheet path sensor located at sheet loading area.(black 'U' shaped part) Applying the pressured air at sensor is the best method to clean.. If problem remain you need to remove the sensor & clean or replace it.
Follow the snaps:

Need to open roll feed right side portion


Clean the IR sensor...
Fix it back..
Note: Technical knowledge required to understand the remedy..

If the paper feeder stuck, do the following:

1. Gently pull any jammed paper out from the output tray or sheet feeder.
2. If paper is stuck inside, open the printer cover and remove the jammed paper, including any torn pieces. Then close the printer cover.
3. If paper remains near the sheet feeder, press the paper feed roller lever inside the paper feeder to release the jammed paper, then carefully pull it out.
4. Load the paper correctly.
5. Press the stop button to resume printing.
   

If the printer continues to jam or misfeed paper, and you are certain that there are no foreign objects lodged down inside the paper feed area, your printer may require service. Please call Epson technical support for further assistance.

Happend twice to me. What sometimes happens is that the paper roll was not changed at the time the ink was. Therefore the paper roll was allowed to remain in the printer until the very last sheet. On the last sheet there is a sticker that says paper out. (stupid idea) This sticker makes the last sheet of paper too thick to fit through the last paper guide / feed. Because of this, the ink film breaks and that specific error message is displayed until that last piece of 4x6 is pulled from the paper feed. Clear that out, and all is good.. Change the paper every time u change the ink.

It's time to take the printer to a qualified printer-repair technician, to get professional trouble-shooting & repair.

Firts remove the back panel by turning the large knowb in the center. Then if more than 2 pages are stuck inside "gently" pull on all the sheets except the top and bottom ones. They should pull out with moderate resistance. Once thos sheets are ou do the same thing with the remaining two sheets.
NOTE: when a printer is powered on with paper already in the paper path it will usually try to eject them by turning its rollers.
NOTE: some older HP DeskJets when you press the paper feed button (with paper already in printer) it will move the paper in one direction and when you press again it will move the paper in the opposite direction.

open the toner place and remove the toner so as to remove the remaining papers inside the printer and plow the printer very well

Hi

Thanks for using FixYa. Perform the steps below in order to solve this incidence:

1. Disconnect the power cord or power supply adaptor from the rear of the HP All-in-One product.
2. Remove the paper pack remaining in the input tray.

WARNING - Do not try to remove the jammed paper sheet yet. Trying to clear a paper jam from the front of the device can damage the print mechanism. Always clear paper jams through the rear access door.

1. Open the rear access door or the two-sided printing accessory.
2. Gently pull the jammed paper sheet out of the rollers.
3. If the paper tore when it was being removed from the rollers, check the rollers and wheels for torn pieces of paper that might remain inside the device. If not all the pieces of paper are removed from the device, paper jams are likely to occur again later.
4. Replace the rear access door or the two-sided printing accessory.
5. Restart the printer to continue the current job.

Please seee this link for more details--

HP Photosmart C5280 Paper jam error

Please do rate the solution and revert for further assistance.

Thanks
Rylee

Had the same problem. Make sure you have put enough paper in paper feed tray (more than 10 sheets) and lock paper from sides. Take out ink cartridge and reinsert it.

Hope this works for you ^_^

That is usually caused by the paper feed rollers being cover with paper dust. Take a clean cotton pad and alcohol and clean the rollers :turninig each roller as you clean it. if it has a rear dor, open it to get better access to the rollers.

Please remember to rate all users who assist you for free :)





I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309