PANASONIC CASSETTE AIRCONDITIONING ERROR CODE NO :- F27-02

Hi.

Panasonic Workio DP-1820P error code E02-01 These instructions describe error code E02-01 solution for a Panasonic Workio DP-1520p, DP-1820P copier machine. This should solve your problem; this introduction will help you to troubleshoot some common error messages related to Panasonic Workio DP-1520p, DP-1820P Error Code E2-01, E2-02, E2-03, and E2-04 that you may receive.

Meaning of E02-01 the Error Code:

E02-01 means the Tray 1 cassette lifting motor unit fault. These machines use a lift motor encased in a plastic drive gear casing. Usually something inside the casing breaks, this usually happens in trays that have Ledger or Legal paper installed. The weight of the paper can cause these gear packs to break. Also if the customer loads letter paper in a tray set up for larger paper sizes.

How to fix the error:

Maybe a problem with tray 1 lift motor either you have a bad motor, Pull the paper tray out and see if the paper is lodged behind the tray, Also make sure the white coupling on the rear wall is in one piece. Check that the flag on the back of the tray is still present. Mostly it is broken and sometimes can be repaired, and otherwise, you have to change it, and to open the back cover and reach that (Part no is (DZTY000357 Paper Lift Motor Assembly, lift up drive).

Some of the possible causes:

• Remove the tray and check for paper behind the tray.
• Check paper falls back causing the gears to break.
• Check cassette Lift Motor connector.
• Replace the Tray 1 lift motor.
• Check the Mainboard.

Good luck.

I told you what to do already

sounds like a paper tray is not fully inserted into the machine. Also check for a smooshed piece of paper behind the paper cassette. The cartridge should have nothing to do with the error. Good luck ....

You appear to have a K-deck mechanism. F06 means mechanism locks during unloading. The cause of which is the load motor and the carriage alignment. Which might explain the stuck cassette. If you look around the net for "Panasonic K Mech" you should find a load of free service information on it.

switch off then on, pull top cassette out slightly. this will provide a temporary solution. a service technician will need to see the machine.

Error 011 indicates an error with the recording paper cassette. Re-install the cassette to clear the error. It's basically the bin that holds the paper that the paper tray leads into. Please post back with any problems or questions or just to rate the solution. Thanks very much!
Greg

you broke the tab on the back of the paper cassette. if you look in where the cassette goes on the back left you will see a hole with a sensor that looks kinda like a upside down letter U . put paper inbetween the sensor and the machine should say out of paper and put the cassette back and you should be fine

Check cassette refers to the paper cassette. If there is no paper or the cassette is not seated correctly, then you will get that error. If you tried those, then check the left rear of the cassette for a tab. If that tab is broken off you will get this error and you need a new paper cassette. Good luck.

most common cause for this problem is defective electrolytic capacitors on the mechanical interface board. a good electronic tech should be able to replace them.

Error code 11 means that it does not see the cassette in the machine,. there is a tab on the back of the cassette that is broken . thats why your getting that code.

if you leave me a msg that you want to fix this i will contact you