I have d-link dp-301p+ print server and i want to disable telnet, ftp and snmp. Dear expert kindly assist me to disable the above services.

I have D link DP- 301P Print server I am using it in Epson M188D Printer for KOT Printing but its shows some times printer not found on network, please help me to solve the problem.
Ajay

Hi
As far as I can remember the default IP is 192.168.0 .10, subnet 255.255.255.0
If this isn't the correct IP address, you'll need to reset the d-link print server Hope this helps
Regards, c0d3

Hi,
Logon to the Print Server web configuration and begin managing the DP-301P+, simply launch the browser (e.g. Internet Explorer) and type dlink-xxxxxx, where xxxxxx are the last six digits of DP-301P+'s MAC address. The MAC address can be found on the bottom side of
the DP-301P+ device.



Default IP Address of DP-301P+ is set as automatically getting from DHCP server or Router with build-in DHCP server. Please note that the PC's IP Address must be in the same subnet as the print server's IP Address for the two devices to communicate. (For example, if print server's IP
Address is 192.168.0.10, with a subnet mask of 255.255.255.0, then your computer's IP Address should be 192.168.0.x, where x is a value between 1-254, excluding 10.)
For additional information, please refer to Dlink printer server DP-301P+ Product Manual

Let me know if any further clarification/ assistance is required.

Good Luck!
Appreciate generously, if the solution could have been of any help!
CreativeTECH

Use PS-Link software in the software CD...

hi
i forgot password Printer Server D_link Dp-301p
Please Help Me

It supports all below protocol so you can give print from IBM iseries .

TCP/IP Protocols Supported :

• BOOTP
• SNMP
• Telnet
• TFTP
• FTP
• LPD
• RARP
• DHCP

usually by resetting it. pushing the reset button on the back it (tiny hole on the back) for 30 seconds, while plugged in to power,

Unfortunately, D-Link doesn't provide a way to reset the password if you lose it. This is from their website:

Forgot Password Unfortunately the D-Link Print Servers are secure and cannot be reset without the password. The unit will have to be sent to D-Link to be reset. Please contact our RMA department at 800-326-1688 M-F 7AM - 6pm Pacific time to return unit (US only). Nick

You need to connect to it (using the broswer at the PC of same LAN with the current ip of the print server). Then click on Tools TAB, click on "Reset" at left. You should see "Do you want to restore this device to factory default setting?". Click on "Apply"

do you have the options set correctly on the remote computers assistant to use local devices