Hi, My Casio Edifice EQS-500C watch doesn't beep when I press "mode" button anymore. I did something wrong I guess when I was setting the time.

follow these instructions off the manual below if you set the watch in wrong sequens it wont change at 12 oclock
http://support.casio.com/en/manual/009/qw5125.pdfhttp://support.casio.com/en/manual/009/qw5125.pdf

Diplodocs - CASIO: 1506 references - Your user manual immediately available! Your CASIO has four push button and one for winding button. the first button has mark of LIGHT , the below button is MODE ,,upper right START/STOP,,, lower is LAP/RESET. the center button is what they called it a CROWN to set crown is just pull it and you can set the hour and minute. the LIGHT button is the set button also, just press it for 15 seconds if dial flashes, then go to MODE button and choose what going to set, the START/STOP -- LAP/RESET is the scroll button you going up and down the number or on /off ,some model of Casio Edifice, the set is in the MODE button just press it long and if flashes it ok. and follow procedure what i said before. setting cannot damage the watch. Feel free to ask question regarding your to watch so i can assist.. Hope this may help;

Regards,
VOTIT

Severe shocks,drops or strong magnetic fields have as result the wrong indication of watch hands.Try to reset your watch by the hands "0 set" procedure following manual instructions.

back of watch is a set of numbers in a rectangle, look up manuals in casio website

Thank you for contacting FixYa.
To set the analog time, press the lower left button 6 times. Next, press and hold the upper left button until the digital time starts to blink. This indicates that you are in analog time setting mode.

Analog time adjustment is completed using the lower right button. Every time you press the button, the analog time will advance 20 seconds. If you need to make a big change to the analog time, press and hold the lower right button to make the hands move faster. Once the analog time is set, press the upper left button to exit the analog time setting mode.
Best regards. Jewel

Thank you for contacting Casio.<br /> You can download the manual direct from Casio. <br /> <a href="http://www.casio-europe.com/euro/watch/edifice/">http://www.casio-europe.com/euro/watch/edifice/</a><br /> Best regards.

Go in alarm mode by pressing the mode button once twice...depending on the modes you have and then press one of the remaining buttons, usually top right button on most edifices. this toggles between alarm on and off. this shall do....

Press the lower left knob till it shows 'H.S.' and then release. Then press the upper left knob once and release. Then press the lower right knob continuously. The analog setting starts.

Does the alarm work? if not, it is quite likely the battery is low. You can tape it up in a window to recharge the battery for a couple of days, direct sunlight is not necessary. Normally "Recovering" flashes. If the battery has been depleted for too long, it is possible the battery is now damaged and may need to be replaced.

As for settings, try pressing both buttons on the right side simultaneously in various modes, especially settings or alarm modes and see if that turns back on the beep. Perhaps press the upper left button for 5 seconds until various options start flashing, then try double right button presses and see what happens.

Hope one of these helps.

Hold down the "Adjust" button (top left) for three seconds. It won't adjust unless you hold the button down.

Press "Mode" (bottom left) to change what you're adjusting, seconds, hour, minute.

Press the top right and bottom right buttons to adjust the number up and down.

Press "Adjust" again when you're done setting the watch.

To change date, alarm, alternate time, etc, press "Mode" to get to those functions before hitting "Adjust."

I hope that helps.