At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
One of the most common problems that causes this is someone may have accidentally turned on the tape monitor switch. You turn the tape monitor on/off by pressing the tape 1 or tape 2 button. Hope this helps.
It is possible that you are not pressing the two buttons at the exact same time. If you press the volume button a little bit before the power button you will have to wait for the volume bar to fade away before you take another screenshot.
If this isn't the issue then the phone might have a programing error
Often, the brake light on dash indicates low brake fluid. Check that first. Cold could affect the level a tiny bit so that warm it's close to low level, cold is on low level.
It sounds the the speaker has damaged. Check it first. If it is found OK, check and replace the audio output card. It is faulty. If you wish to get more details, surf the following
link. There are over two thousand and
four hundred posts. All are related to
television and other domestic electronic equipment service help. You can get a solution there. Type in the
brand name to your device to its search box, can be located at the top right of
the display window. It will make search
easy. More than Nine Lakh viewers
cannot be wrong. http://electronicshelponline.blogspot.com/
The procedure is a little bit tricky so that you do not do it accidentally.
1. Turn on the television.
2. Press the volume down button on the TV display (not the remote)
3. While pressing the volume button, press the "split" or "PIP" button on the remote.
If it works you will see a message saying the lamp timer was reset to 0 and the indicator will turn off.
Remove any screws you can see and pry the case open. you will see a rubber pad and a circuit board. Clean both with alcohol and dry. reassemble and it should be OK
Hello..if you can try to connect a external speaker or phones..if the volume is ok..than i think it is time to replace your internal speaker..pse tll me....good luck...Ron
Do you mean that by pressing the volume button it changes the volume to one of these 'extreme' levels only? In either case it sounds like a hardware problem as in probably not DIY.
Sorry.
×