Can i send my ranger 2950 to ranger to get fixed?

The + side of the cell is smooth on the top (no seam), and the - side has a seam going all the way around it as shown below:



This side ^ is (+) and this side ^ is (-)

get hold of ranger and they should be able to help you.

have you tried it on all bands? still won't transmit?take it to a tech so they can fix it properly.

i have the same radio rci 2950. Ive had the same problem with mine,turns out with mine the processor would lock up,turning the radio off & on repeadly would clear the problem and the radio would work fine x-mit & recieve. the solution to fixing the problem is to replace the memory backup battery this battery works similar to a computer motherboard cmos battery when this battery goes dead all sorts of strange things happen to the radio wont transmit wont recieve or like your problem transmits continiously. the problem with replacing this battery is finding out what year & model your ranger 2950 is. the internet says only first generation ranger 2950s use the battery second genration & third generation do not use the battery. but the internet could be wrong. so i suggest getting a hold of (usa ranger.com) & give them a phone call or email and ask them about the year your radio was made. they may even service it for you or if you are electronic savvy you can do it yourself. the battery is located close to the main cpu on the front panel if yours uses a battery.

could be a number of different problems causing this. I would start with your microphone make sure it is working. it is responsible for transmit & recieve. next check to see if the memory battery is dead this will also cause this problem. next check the regulators in the radio to see if they are supplying voltage.next check voltages in different parts of radio to see if all stages are recieving power follow these steps and something will show up also check your switching diodes to see if they are bad the diodes responsible for x-mit & r-mit of transceiver.

check the ground wires

Bad mic? dirty mic pins? If the mic is bad, you will have no receive.

replace memory battery its a CR2032 battery Radio Shack and Walmart has them from $3.65 to $5 in price.

Hello, Just offhand I'd say you have a bad solder joint on the main circuit board. Without more info, I can not tell you where to look,,,,, Mechanic

1 shield & blue
2 white
3 red
4 black
5 n c
6 n c
yellow.. n c