DEWALT DG6300B NO POWER OUTPUT - Garden

Likely the GFCIs won't reset without power from the genset.

Check voltage at twist locks... see voltage select switch.

It should change with the load, the more load you put on the line the magnetic field increases with the amperage and the gen will produce more output until its rating is reached. This happens especially if it has been sitting a long time.

Or only the Circuit breaker is or even a damaged capacitor gs0748 40 uf 370 v pos 260 to find by the electric stator(magnet field) or electronic control modul , try to control first the slide contacts on it, If there is enough clamping tension on it.

Check your fuse

Sound like one of the Capacitors on the Power Supply has blown.

If it's the same on both AC & DC then its probably on the output of the transformer.

If you can open it up and post pictures or see if one has a buldge in the top or liquid leaking out.

check output voltage on charger label most chargers are not regulated so if it says 18 volt output it may put out 24 volts but if its putting out 51 volts it may have a short batteries will get warm but not hot replace charger

Check the service breakers first

Here is DeWalt's marketing thing on the subject.

http://www.dewalt.com/us/cordless/powerrating/

Unit Watts out (UWO) is their rating for the (presumably sustainable)maximum power output at the chuck of the drill. You can read about it..their explanation is basically technically correct.

Yes, max torque is related. The maximum power in a permanent magnet DCmotor system occurs at half the maximum speed when the system is loadedwith half the maximum torque.

1hp = 746 watts, DeWalt's DC900 36V drill is claimed to be 750 watts,close enough so let's call it 1 HP ok? Their max RPM is 400. So 200 RPMis the half-way point.

1HP = 200RPM*Tmax(in-lbs)/(24*5252)

Tmax = approx 630 in-lbs

The equation I used is known equation for relating power (HP) to RPMand torque (in ft-lbs..I added in the factor of 1/12 to account for thein-lbs to ft-lbs conversion).

By the way DeWalt make some bold claims about other manufacterers' drills.

For example they claim the 18V Lok Tor by Milwaukee puts out 390 UWOcompared to their DC988 model listed as 420 UWO. Yet I have readinformation from Milwaukee's own independent tests that claim the LokTor drills faster 2 9/16" self-feeds AND more self-feeds per batterythan that very DeWalt model.

This was posted on Milwaukee's Tool Talk forum (when it existed). Ibelieve the Milwaukee official said that DeWalt averaged 7.2 secondsper hole while the Milwaukee averaged 6.4 seconds per hole. I make beoff slightly but I do remember it was around a 1 second difference.Plus the Milwaukee apparently drilled 28 holes per batt where dewaltwas 25.

You need to use a Voltmeter and go right to the Output Terminals on the Generator, Disconnect anything from them, and measure that Open Circuit Voltage. If it is OK there, then the conditioning circuitry AFTER that is faulty. BE CAREFUL.

Measure the output voltage, if it is low then you must replace the charger, they don't sell parts to repair them.