Clicking noise when turning on the tv. Everything works but the clicking.

Clicking noises from the drive wheel area usually means the gearbox on that side has a minor to a more severe issue. Call the place where you got the chair. I'm glad it's running and it could continue to run even with the clicking noise. It could be something as a loose hub nut on the wheel or something rubbing when you are making a turn.

that click is the power relay, but i have seen several diferent ways this can happen, is it clicking so fast it kinda resembles a buzz noise or do you just hear one loud click when you turn it on? email me [email protected].

If u turn the key and all it does is click its ur starter I've worked on cars my whole life just about and I'm only 28 lol

The tv power supply board is dead,replaced the power supply board should solved this.Tries webstes like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Take the tv aparts,take some Q tips with some rubbing alcahol clean the DVD laser eye.Should help the DVD player side to work,than the tv might go in to the functional modes.

Replace capacitors in power supply you will see that they are bulged on top

The clicking noise is a protection circuit that prevents the TV from switching on when a fault is detected.

That means that there is a short, a bad solder joint, or a bad component inside the TV, usually any good technician is able to find out at least the nature of the fault. Often this jobs must be done at a repair shop, as testing may take time, probably your technician was just in a hurry.

All you can try at home is leaving tv unplugged for a couple of hours, this drains power from the set , and fix some problem.
If it does not work send it to a repair shop.

Check the fan, it may be dust or a bad bearing.

ok this is a bit complex but im going to describe to you what you have to do\ 1) TAKE THE BACK COVER OFF 2) LOOK FOR WHERE THE SWICJ IS LOCATED 3) LOOSEN THE SCREW WHICH HOLDS THE BUTTON 4) CARRY ON LOOSEINNING BUTTON UNTIL YOU CAN PRESS IT 5) THEN CHEC IF IT WORKS IF IT DOES TITEN THE SCREW AND PUT COVER BACK ON IF NOT THEN CONTACK ME

YOU might have a bad relay or a bad solder connection in the relay control circuit. Sounds like a bad solder joint. Stargazer