I have the hp laptop it has a pink screen i have had repair people look at it and they can't find the problem it has had new screen new cable from screen they have connected it to a moniter and it works fine so they don't think its motherboard they have checked for any loose or solder breaks and found none help please

SOURCE: HP compaq 9010 laptop

get a new battery.


It happens a lot at our school. We have nx9010's and I'm always replacing the batteries.

SOURCE: HP Laptop sound and power button trouble

Dear LaxDude,

It seems that the problem lies in a type of cable called a ZIF connector. There are two of these cables attached to two different boards on the laptop. The first is attached to the power board, and the second is attached to a board that controls the LED touch keys. The ZIF is essentially a small ribbon cable. The problem arises when the cable weakens and breaks due to repeated flexing (pressing of the power button). What ended up happening to my laptop was quite simple actually. My friend and I replaced the broken ZIF cable with other ZIF from the LED touch pad, since I don't use them that much. And voila the problem was solved, both speakers work now and so does the power button. This will do for me right now until I find out where to get a new ZIF cable.

To open up your laptop:
Step -1:
Un-plug the laptop and remove the battery

Step -2:
Flip the laptop over so the area where of the battery compartment is facing up.
Remove the three Phillips PM2.5X5.0 screws at the back of the of the battery compartment to remove the switch cover.

Step -3:
Flip the laptop over again and open the laptop as far as it will go. Remove the switch cover by pulling up from the back of the cover.(The switch cover is the piece with the speaker mesh)

Step -4:
Unplug the first ZIF connector to which the LED board is connected.
Remove the four Phillips PM2.5X7.0 screws which connect the keyboard to the laptop.

Step -5:
Remove the keyboard and rest it over the mouse pad.
Then remove the small circuit board from the switch cover.

Step -6:
Remove the ZIF cable from the power board and replace it. either you can find a new ZIF cable or you can swap it for the other one. Be advised that if you swap the cables you will lose the the ability to use the touch keys.

To put everything back together just follow the steps in reverse order.
It is kind of to explain and to take apart a laptop without pictures. But I will just give you the information and you can decide if you want to take the risk.

Best of luck I hope it works,
DarranK

SOURCE: HP Laptop sound and power button trouble

You don´t have to replace it. Just cut about 1,5 - 2 cm off the end (that´s where mine was broken) and scrape the tracks free with a knife. Then but a small batch of tape behind the end so it will be held in the socket. That´s it, a 10 min fix.

SOURCE: internal speaker problem

connection frayed
um haard 2 fix if u want i can give u a step by step how 2 fix

just contact me at [email protected]

SOURCE: problem with my dv2315nr or dv2000

If the Product Number of the Notebook is RV324UA, your Notebook is eligible for free mail in repair program available through HP if it is purchased in US and is currently available in US.

You can find the Product Number printed on a white sticker pasted at the Bottom of the Notebook indicated by P/n .

You can find the list of Product Numbers of Notebooks that are eligible to get repaired for free listed in the link below :

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&cc=us&docname=c01300427&dlc=en

You can find more information about this service program from HP from the link below :

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&cc=us&dlc=en&docname=c01087277#c01087277_identify

Hope this helps...