My Trinitron KV-35S42 picture folds up. - Sony KV-35S42 35" TV

You need to be a little more explicit about what you need Jackie. Code programming? for what? what device? or name . . or something more . . try again. You'll probably get plenty of help on this one.

my best advice would be to check power supply for faults, bad capcitors etc to r/o the possiabilies of a power failure.

Thanks

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

After 13 years, the most likely cause is a tired picture tube. There are adjustments that can be made to address this, but they would be short lived. Rather than spend money on this set, put it toward a replacement. After 13 years, the set owes you nothing.

Dan

tv wont turn on when i hit power it makes the clicking noise like it is going to turn on, but never does and the red timer light next to the power button just flashes.
help!
trinitron kv29f1u
only clicks and blinks

All the above connected method is correct. Need to change the option in the stereo system as md or auillary depends upon the model. Go through user manual for stereo system.

Usually, the CRT is bad......re-juvenation is a temporary fix at best........try adjusting screen control on CRT socket module.

Only other possibility is solder pins of vertical output IC.

Your Model # is KV-35S42 and most likely you have a bad picture tube......you might see if you have a de-mag problem..
ask a local repairman to de- gauss the tube...
Was the TV moved / dropped ?...................................T.

HI
Don't beat it with a bat LOL, the problem your having is a simple solution, however this would be best left to a qualified tech to do, the Screen Voltage needs to be tweaked up just a tick, I've worked on alot of these sony's and 9 times out of ten thats what it is.

Mark

change the trc

Check first for bad solder on the vertical IC, Im not sure for your set as I do not have the service manual, but it may be location IC301. If after resoldering it does not fix it you may have to replace it and you should replace the electrolytic capacitors in the vertical section. Hope this helps. Don