Hello
Most people think that replacing a microwave door handle simply involves unscrewing the old one and mounting a new handle. The process is a bit more complicated than that.
Unplug the microwave oven from its power outlet or turn off its circuit breaker.
Open the microwave door and take the top pin off its pivot bracket. Lift up the door and remove it from the bottom bracket. Lay the microwave door with its front side down on a folded towel. Remove the two choke screws from the door frame using a Phillips head screwdriver.
Remove the choke cover with the knife blade, starting from the microwave door's top right corner. Pry out the bottom and top right sides, leaving the side which houses the door handle in place.
Remove the choke tabs from their slots on the microwave door frame using the knife blade. Continue to work clockwise around your microwave door; remove the choker cover when you get to your handle's side to separate it from your choke.
Remove the two handles with the Phillips screwdriver. Remove the handle from the microwave.
Screw the new handle in the position of the original handle. Lay the choke on the microwave door; set the choke cover right on top of it. Insert the choke tabs into their slots on the microwave door frame using the knife blade.
Secure the two choke screws using a Phillips head screwdriver; set the microwave door back on the bottom bracket. Slide the top pin into the microwave's pivot bracket.
Press the top pin down until it pops securely into place.
Hi,
This will help you:
http://www.searspartsdirect.com/partsdirect/part-model/Sharp-Parts/Range-Parts/Model-KB3300JS/0958/0124500/50027323/00003?blt=06&prst=&shdMod=
Hope that helps, please rate my help if it does.
Adam
Hi
You can check out these links to
buy Sharp Microwave in UK:
Hope this helps...please post back
for further assistance.
Daniel
179 views
Usually answered in minutes!
thanks for the info. have been to this site and it does not give me a good disassembly drawing for me to remove and replace the drawer handle.
Thanks again.
does the back of the drawer just snap in as i do not find any method of attachment other than the 4 screws below the drawer for the SS face?
Mike O
This is an above stove built in microwave model # nn-s253WF
×