The LED "new message" indicator on the upper

If your charge light is flashing and you have no messages on your answering system, you may have voicemail. Voicemail is provided by your telephone company and they would be able to assist you with retrieving those messages.

Once you have listened to the new messages, the blinking light will stop. You may also be hearing a stutter tone before your dial tone when turning on your handset. This is also indicating you have a new voicemail message.

Go to the base station of the D1780, press Play. Alternatively, when all of the handsets are in standby, press Message/Mute (below 0 on the handset) on one of the handsets. Then wait until all new messages have been played back. The blinking light indicates new messages on your answering machine.



You can find this information in the manual on page 16. Uniden has the manuals for their phones on their support site: http://www.uniden.com/scat/dectphones_mnl . The direct link to the manual is http://www.uniden.com/content/ebiz/uniden/resources/ownersmanuals/D1780om.pdf . (Note: you will need Adobe Reader or a similar program to view or print the manual.)



I hope this helps.



Cindy Wells

You apparently have unheard messages on the voicemail system provided by your telephone company. This system takes messages when people call while you're already on the phone. Please contact your telephone company for instructions on accessing their voicemail system.

That is the message waiting indicator, it is telling you that your Call Notes (Or whatever your service provider calls it's voicemail) has a message waiting. If you do not have a message waiting, you can turn the light of by following these steps:

Resetting the voice message waiting indicator
When you receive a new voice mail message, the new message LED on the top of the handset flashes and
appears in the handset display. In the event your message waiting light gets out of sync with your phone company’s
voice messaging system, you can manually reset it back to the “No messages waiting” state.
Press and hold FIND on the base for five seconds.
Note: The handsets connected to the base will start to beep, however, keep pressing for five seconds.
A beep sounds and the message alert tone is reset.

There is an old message stuck in memory. Hold down the OFF button on the base handset for 10 seconds.

Press down the "find handset" button until the paging beep stops (about 5 seconds) and this will reset the indicator lights on the handsets.

Try pressing and holding the "find handset" or "page" button on the basestation until the phone stops beeping. This should clear the new message LED indicator.

What worked for me was to call my phone and leave a voicemail. I then retrieved and deleted my voicemail which reset my handsets.

I hope this helps!

Your phone may have lost registration to the base. 1) Try disconnecting the power to the base and then re-connecting the power with the cordless phone in the base. Give it a few seconds, then see if it works. 2) Try removing the battery, wait 10 seconds, re-install the battery and set the phone in the charger.

Resetting the New Message LED
If the LED remains on after you’ve retrieved your messages, you may need to reset
the indicators. With the phone is in standby mode, press and hold find handset on
the base until the paging sound stops (about 5 seconds).