I have a Movado series 800 model 2600075 watch. I lost the manual and now need to change the time setting. How do I do that? Thx.

I was told my a jeweler that Movado condiders that. Design defect and they don't produce or offer that rubber insert for sale.

CLICK THIS LINK FOR THE MANUAL
http://s3.amazonaws.com/szmanuals/7d56ee172abe8d36a500774f36bb606f

you do not need to return, as this is re-settable. Pull out crown to the first position (date setting) and then toggle with upper push button. If upper button do not do the job, try the bottom one. When you reach 12, then push the crown back in. Start the chrono, stop it and check if it returns to 12.

Try this site. I have the same watch and the instructions are avaialable from the Movado support site: http://service.movadogroup.com/movado/

it is probably either in set time mode, or some sort of chronograph mode. play with the buttons.

Try pulling the crown out and using the reset button to move hands beside the sweep arm. If this doesn't work then you may need to take it to a repair shop that can reset or AC the watch. With a movement as fine as Movado I wouldn't attempt this yourself. If you make a mistake the repair could cost more than the watch. Be sure that you have the watch resealed so it maintains its water resistance.

Go to their web site http://www.movado.com/Service.aspx and click on Download ....................series 800 operating instructions ................."

Turn the crown of the watch towards you until it pops out... After the crown pops out, pull on it to extend fully and you should be able to change the time at that point

mcdevito75 here, Movado a FINE watch, BEST BET, look for a small watch repair shop in your area to change the battery, Movado watches have a very good over all value and any damage can lessen that value, not to mention the jewelers screwdriver you"ll need to change that battery.

The chronograph can be reset by pulling out the crown to the first or second position and pressing the start button or top button. This will begin to move the sweep arm and you can stop it on the 12:00 or 0 position. Make sure that when you have the battery changed they do this for you.