I dont have problem just i need driver to my router model WAG200G Annex A

You can start here : http://homesupport.cisco.com/en-us/support/gateways/WAG200G OR http://compnetworking.about.com/od/routers/g/192_168_1_1_def.htm

The network adapter driver in your computer (not the router) has to be installed. If you've replaced the Operating system to XP, it is likely missing the driver. Suggest go to another computer that is connected to the Internet and download the driver to a flash drive - you must go to the manufacturer of the computer's website to get it. Then transfer the file on the flash drive to the computer missing the driver and install it.

Follow this link:

http://www.linksysbycisco.com/AE/en/support/WAG200G/download

You will find everything you need there.

Are you wanting to expand the ports available to your internet connection or simply increase the coverage area. I suppose it's the same in the end. What would you like to accomplish?

u can go to the manufacturers web site that will be http://www.linksysbycisco.com/ANZ/en/support/WAG200G/download and select the correct hardware version and u can get the drivers for ur linksys wg200g from there .

just reset it the router then again configure it then you get it

Go on Gateway's website and put in the model number and request a new CD.

Normally for routers or gateways you can check the actual model number on the device itself for UK devices usually they will affix letter A or B next to the model number to indicate which region it belongs. Open region routers and gateways are compatible with region A locations but not with region B.

it is highly probably annex B (same type as mine), but by mistake I flashed it to annex A (newest firmware from Belkin UK), but there is no way back to the old annex B, beware before you try...

Conversion of WAG160N from Annex B to A is not possible. The firmware for Annex A is only for Annex A only and the firmware for Annex B is for Annex B only.