How to change ring tone of kx-t7730

When you put a call on hold you should get intercom tone. At that point you just dial the 3 digit extension you want to speak to. That ext should ring or have a voice page. Make sure the auto answer button is lit on the phones to do voice page

You don't. Panasonic analog system phones have one ring tone. You can change the cadence (single double or triple) ring from outside calls, but not the tone.

Carl

Analog Panasonic phones have one "ring tone". You program it to ring or not ring, but the tone is exactly the same. Ringing programming is in SYSTEM programming in the 40x's, depending on the cabinet. In a TA series, inbound ringing is program 408 409 and 410.

Carl

This is most likely a service provider issue. If these are analog lines, take a regular phone, not a Panasonic system phone, and plug it into wherever the CO1 CO2 CO3 lines go into the cabinet. If they work there, you have a system fault (not likely). If they don't you have a line problem.

Make sure that you plug the phone into the lines coming in, not into the cabinet :-)

Carl

did yo you get that,just rate me if yo like.

Message/Ringer Lamp: The Message/
Ringer lamp informs you visually that you
have a message or a call.
When you receive a call, the lamp
flashes depending on the ringing pattern.
When the ringing pattern is set to Single
(Slow flash), Double (Moderate flash), or
Triple (Rapid flash) in your PBX, the lamp
flashes. When the other ringing patterns
are set in your PBX, the lamp may not
flash. (e.g., S-Double, Call Waiting
Tone1).
When someone has left you a message,
the lamp is lit continuously.

Please note that the above indicates that ring patterns are set in the the PBX. These are issues that require a real person to sit at the main system and program the features that users need. I hope you have an I.T. person that knows your phone system. If you don't, you'll have to find a communications company in your area that can program your system. Thanks for using Fixya.

I think it can be done. Just exchange the phone for a 7633 and change out the TA for a TDA-50.

Piece of cake.

Carl

i have 10 extentions but my call ring to all extentions. but the ring to one extentions 101 only plz tell me

Depending on your model system, it may or may not be possible. I included the two different methods to change the ring tone below depending on your system. Give it a try.

KX-TDA Systems
KX-TD Systems
Press PROGRAM
Program Press the CO Line key you wish to change
Press the same key again, enter the tone number (01 through 30)
You will hear the tone associated with the tone type number. For example, if you press 02, you will hear the tone associated with tone type 22. Press each number (01-30) until you hear the tone you desire.
Press STORE
The tone is now stored for that line on that phone only.
Press PROGRAM 99 (or PAUSE 99 if you do not have a PROGRAM button
Press the CO Line key you wish to change
Press the same key again, enter the tone number (1 through 8)
You will hear the tone associated with the tone type number. For example, if you press 2, you will hear the tone associated with tone type 2. Press each number (1-8) until you hear the tone you desire.
Press STORE
The tone is now stored for that line on that phone only.

There are a number of ringing patterns which are programmable in the main switch unit, however I can find no information on various ring tones in the manual.........sorry.