Instruction Manual for RCA Easy set Clock/Digital Radio Model RP3765A

Hi lufberg,

I see you need help with your radio controlled clock.

Place your Seth Thomas atomic clock face-down on a table or desk and locate a series of buttons labeled "PST," "MST," "CST" and "EST" on the back of the clock. Press the appropriate button to set the time zone.

Turn your attention to the small lithium battery-powered digital clock display on the back of your clock. With the correct time zone set, the digital display should accurately reflect the current local time.

Locate the AA battery compartment on the back of your clock. Put two new AA batteries into your clock's battery compartment.

Set the "Mode" switch on the back of your Seth Thomas atomic clock to "Run." Wait for it to adjust to the correct time. The automatic time-adjustment process can take up to 45 minutes, but is usually completed much sooner.
Read more: How to Set a Seth Thomas Atomic Clock ' eHow.com http://www.ehow.com/how_6120534_set-seth-thomas-atomic-clock.html#ixzz1REo5s6T9

I hope this will help.

Thank you for choosing Fixya,

mvincentc

I actually have one of these. Pull the back cover.it might be in there.otherwise i can email you pictures of mine

The Rc-95 has a switch underneath and should be on when you want to set the time..

Good afternoon,

Equity has the instructions on their support page, but no actual instruction sheet is available:

http://www.equitybylacrosse.com/i-need-instruction-manual-my-model-40001-clock

Hope this helps! Please rate this solution.

Thanks,

~PCF

For most clocks of the RCA clocks without a clock or time set button, press Set until you see the clock icon. Press the fwd or rev button to change the time. Release the button when you reach the correct time. (AM or PM will be indicated next to the time.)

There are manuals for several RCA cd clock radios available from their site: http://support.rcaaudiovideo.com/select.aspx?u=manual . Check if your specific model is listed in the menus.

I hope this helps.

Cindy Wells

in your browser type in make and model/manual to find the imfo you need

You have tried re-setting it, Right?

What happened when you did?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Note: This problem ended up under Vacuum cleaners-
You might want to try re-listing it again-- under Electronics?-

Mack B

The power supply circuits are probally burnt out. The cost to repair would be greater than buying a new clock radio. Sorry.

how to set it up?????

Hi,

You can download and print the instruction manual in PDF format by clicking this link.

You'll require Adobe PDF Reader installed on your computer to view the manual. If it is not already installed on your computer, download it free from: http://get.adobe.com/reader/

Thanks for using FixYa.