My oven registered F1 err when I push bake/broil and can't use the oven. Libby

Technical sheet says all F1 codes to replace control

It may be possible that the electronic control is bad. On some models there are three relays one for the bake and one for the broil and one for the common. This one goes out and the bake and broil will not work. The control is fairly expensive you may want to have a tech check it out.

Your range has been reset to celsius from fahrenheit. It must be reset to fahrenheit.

Press bake and broil pads simultaneous for approximately 3 to 4 seconds.

When SF comes on, press the broil pad.

You should see the Letter C.

Press again and the letter F will come on.

Press start.

Your range shouldproperly set the temprature now!

Use the FORCE Luke

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

says F1 will not stop beeping. unpluged and waited still beeping!

Hello there:
first chevck to see if the broil feature will work but if both the broil and bake feature does not work meaning it will not heat up if you have selected either the bake or broil follow these solutions that i have provided for you .
It won't bake or broil If neither the bake nor the broiler heating elements heat, but the range burners still work, the clock may be set for a timed or self-cleaning cycle. Check to be sure the clock buttons and knobs are set properly. If your clock has a knob that says "push for man(ual)", push the knob in and try the baking and broiling elements again. If it still does not operate properly, you probably have a defect in the thermostat, selector switch, or common wiring. If the oven does not have a separate bake/broil/etc. selector switch, the problem may be with the thermostat. But it's not easy to check the selector switch or thermostat for proper operation. If you suspect a problem in this area, call a qualified appliance repair technician.

Usually, when an oven won't bake, it's because the bake element is burned out. The bake element is the black, pencil- thick tube at the bottom of the oven. When the oven heats, the element glows red. This element has an expected life-span of several years. It may last for only one; it may last for many more. When the element burns out, you need to replace it.
or try doing this
1. Turn the clock selector knob to OFF
2. “Tweak” the oven control by turning the clock selector knob slightly to the left (counter clockwise). This may stop the flashing message/beeping and clear the display window.

Press and hold the Broil button for 5 seconds. You will see the c change to f. THen change the temp to what you need.

Try http://www.applianceaid.com/fault_codes.html

Have you tried to broil or bake? if only one of them work you have a bad ignitor. let me know and we can go deeper