KENWOOD TM761 TONE INSTALLPROBLEM - Xact Communication X32X-2 2-Way Radio

Grasp the lift bar that the tonearm is raised by, and pull it gently up, and push it back down 2 or 3 times. That re-distributes the silicone fluid, and usually brings the nice, slow drop back. No dice?

Check to see if there is an internal button battery that saves settings. If it is dead, your settings will disappear as soon as you turn off the power.

https://www.manualslib.com/manual/86621/Kenwood-Krf-V7773d.html?page=36 http://www.manualsbase.com/manual/428671/stereo_receiver/kenwood/krf-v7773d

Hello
Not possible to adjust the tone without the remote.
if you have the possibility for a universal remote like "Logitech" remotes its Recommended for such cases, that will be easier for you to control the the AVR system.

The CTCSS (sub-audible) tones are not matched between them. Either turn Tone Squelch off, or set them all to the same tone.

1st try a test tone to the rear speakers. If you can not get a test tone check the connections again.. once you get a test tone, use the "mode" button on your remote to cycle through the surround modes and make sure you are in a surround mode rather than a stereo mode.

I bought Kenwood TK 7102 VHF radio, but it was programmed and I can listen the dispatcher but can not transmit to him. Any solution please help.

are the batterys charged?
Are the battery contacts cleaned

The tone squelch coding is not matched - check the programming

Unit apparently has problems. Check/replace batteries in remocom