EVERY time i turn it on, it goes straight to red light immeditly turns on, but before i switched subs, it worked, but now that i changed them, and took them out, it no longer works, i rehooked up everything, disconnected it, and now all i have is the standard hooks up, power, remote, ground...no speakers and it still dont work..i was wondering if there is a way to by pass it or, fix it..thank you for your time
If it goes into protect mode with no speaker wires connected to the amp, it sounds like the audio output transistors have shorted. If that's the case, they would have to be replaced. It would require troubleshooting to find the shorted parts. You'd then have to disassemble the amp, desolder the defective parts and install the new parts. The following page provides the basic information needed to repair the amp.
Basic Repair Primer
219 views
Usually answered in minutes!
×