Technics sl-ql 15 linear tracking T/Table

Two Speed Direct Drive Fully Automatic Turntable with linear tracking ... Technics SL-L3 / SLL3 owners manual, service manuals and schematics are for ... www.vinylengine.com/library/technics/sl-l3.shtml

hope this will be of help

You definitely want to make sure that your new cartridge is properly aligned for your turntable. This web site can help:
http://www.audiophilia.com/features/cartridge_setup.htm
If you don't feel that you are able to get it properly aligned by yourself, a local dealer should be able to help you with this for a small fee.

You can fit whatever will fit on the headshell of the arm. It depends on how much you want pay otherwise for one.

The grease and lube in the mechanism will
need cleaned out and replaced due to the
"age" of table! The "lifter" may be bound
up due to grease drying out...

Earth cable available here :-

http://cgi.ebay.co.uk/TECHNICS-GROUND-WIRE-SL-BD20-SL-BD22-BD22-NEW-PART-/300419439062?cmd=ViewItem&pt=Turntable_Parts_Accessories&hash=item45f264d9d6

No, you should not need to install extra weights. Adjust the tomearm counterweight (on the back of the tonearm).
Install new cartridge.
Set tracking force dial to zero.
Adjust counter weight so tonearm floats vertically. This is the balance point.
Dial in tracking force, 1 to 3 grams.
If you cannot achieve balance point then you may have to add weight between the cartridge and the cartridge mount

Try adjusting the tone arm weight so that the arm will be slightly heavier.

If this does not help, see if the tone arm manual lift handle is operational and fully released when the arm sits on the record.

Another possible cause are the tone arm position sensors inside the unit.

Hope you can fix it.

regards

Triarcuate

technics used special grease for lots of their products, any good quality grease will do but use sparingly

try gently pushing the tone arm (actually the piece of plastic holding the tone arm) over to the right a little. works for me, but it still gets stuck often

hello

You need a belt.. Lift up the record support..(platter) Underneath you will see a metal post.. Belt goes around that and the bottom of the plate.(there is a rim) . If the belt is there, motor might be bad..