Hey i cannot get to login to my paradyne 6381 dsl modem the page isnt even comming up

There will be 4 lights...

Power
Dsl
Internet
Ethernet

Power light indicates power supply is good...
Ethernet light indicates connection between modem and computer is good...
DSL light indicates connection between modem and telphone line is good... Also DSL light should be steady and it should not flash...
If it flashes then it says there is a lot of noise in telephone line...
Internet light says whether the internet status is connected or not...Internet light can flash depending upon the internet activity...

Since your D-Link 2640 is a modem + router it may not work the way you intend.

You need just a wireless router without modem.

Run a small Ethernet patch cable from your Paradyne modem into the WAN port on your router, you can plug your existing Ethernet cable into one of the other LAN ports on the router, then access the router setup using the computer connected to the Ethernet cable using a browser and putting the router's IP address into the address line of your browser. It will most likely be 192.168.0.1 or 192.168.1.1.

Once you have configured the Wi-Fi router you will have your wireless network. Full instructions should come with the router.

Routers are available for as little as $29.95 but expect to pay closer to $79.95 for satisfactory speed and capability.

you will find the drivers that you are looking for on this web page:
http://www.zhone.com/support/downloads/drivers/
they should be the 2nd or 3rd from the bottom

To configure your router, open your web browser. Type the default IP address (http://192.168.1.1) into the Location field of your browser and press the Enter key. A Login screen will appear. Use the below to log into your router.

The default IP address is 192.168.1.1
The default user name is Admin
The default password is Admin

Both are case-sensitive.

The IP number is: 192.168.1.1.
The login info is UserID: Admin (case sensitive)
The password is Admin (case sensitive)

Also here is a link to the users manual:

http://www.zhone.com/support/manuals/docs/62/6210-A2-GB21-10.pdf

Good luck and if you found my solution to be helpful please rate it.

eat poop

It's not wireless

first write 192.168.1.1 on address bar a login window will apear write user name and password admin

connect your computer to it

go to start->run and type "cmd", press enter

type "ipconfig"

look for "default gateway..." and note the ip address(ie http://192.168.1.1)

go to your browser and type
http://192.168.1.1:8080

if that doesn't work..type
http://192.168.1.1

you can always call your isp technical support and ask them for it.

I have modems 6381-A2-200, sw ver.03.00.10. This model does not support pptp-connection.