Had to change the battery in my Python Keyless Start/Remote and now it wont work. How do I reprogram it

Need to reset/re-program it as specified in the user manual. When the keypad loses power during the battery change it loses the original settings and need to be reprogrammed. New keyless pad also need to be programmed to link with the receiver.

Tools: 10mm torque wrench
Step 1: Find the release bonnet lever or button in the car.
Step 2: once the bonnet is open, locate the battery pack.


Step 3: Then locate the negative charge and unplug the connector to the terminal by using your torque wrench.

Step 4: Then replug it in and close Start the car up and it should work.

Hopefully it works.

You need to provide the model number off the brain, not the remote.

go back to installer for reset guidlines

You may have lost the memory or the battery is dead(might be) or incorrectly installed. Sometimes you have to check the little contacts to for proper tension against the correct points of el trans.

try disconnecting battery in car then reconnecting...might help.

474P. Additionally, the 474T, 474V, and 474L will also work.

The "pair" the remote with your system:

1.PRESS AND HOLD the f button on the remote UNTIL the transmit LED lights solid (approximately 10 seconds)
2.PRESS AND HOLD the remote start button (circle arrow) UNTIL the LED blinks 3 times and the amber transmit LED lights up. Your remote is now ready to pair.
3.. Turn the key to the on position
4.Within 5 seconds PRESS AND RELEASE the control button on the antenna.
5. Within 5 seconds PRESS AND HOLD the control button. The status LED will flash one time and the siren will chirp to confirm that the system is ready for remote pairing.
6. Press lock button on remote. System will respond with chirp toconfirm pairing.

your remote needs to be reprogrammed