I habe problems with an asa 5540, all the leds turn on at the same time and do not boot, not even send any information. where could be the problem regoard

Try to reset the device again and connect to a different power source.

There isn't a set time. It is a good practice to turn it off long enough that the electricity can actually dissipate. It certainly won't hurt anything to leave it off for a minute before turning it back on. Even removing the power cord in between is ok.

Hi the documentation lists it in detail if you donot have the docs then access the same on Cisco web site it is free

Hello,
Seems like you need to send your phone to Dr Cell Phone for Diagnostics. They can do Cell Phone Diagnostics and tell you exact problem with your phone. Their diagnostic service is only $24.99. For more information visit www.drcellphone.com

A conflict in the IP address, resolve it

This model monitors the fans, should one not work the set should not even turn the lamp on, leaving only the timer LED flashing. Recheck your work but you have had other problems to begin with. Be sure the covers are reinstalled properly. Are you getting a Temp LED that is lighting? If so then the Temp sensor needs to be replaced.

Hi Thangaraj_j,

Can you provide the topology of your setup? Can you provide also the following:

- running configuration of the ASA
- ip address of the server (what kind of server is this? what tcp/udp port does it use)
- show xlate
- show con
- show log

Just a quick try, have you tried clearing the translation and the arp table?

commands to do it:

clear xlate
clear arp
clear local

Let me know and if it still doesn't work, try to ping the server from the pc clients and see if ping does work. (you need to allow icmp to pass thru in case you are denying it for testing purposes) Just send me the additional information given above.


Regards,

ex_ocsic_cat

I too had this problem. I had owned the F4s from new but only lightly used it. A single shot only then the red light flashing. Nothing I tried corrected this inc changing batteries, resetting DX / ASA setting etc. Even opening the camera back to ensure the film was feeding (one cause) and finally running an old film through on the fastest drive speed. Eventually I had to take the camera to a Nikon repair agent who charged me £230. On the first shot when I got it back the same happened. Naturally it went straight back and they kept it for another 3 weeks. I now have it back and it's OK (so far). I still did not get a satisfactory answer to what was wrong but I was told the top and bottom drives had been rebuilt. Sorry this is not a quick fix but I don't think there is one. to hThere is nothing in any of the books or manuals to help or even mention it. best wishes Brian

I habe exactly the same problem. I habe the P45 Neo3 Board with E8400 CPU and 4GB Dominator RAM(1066MHz). No signal aber reboot. A Bios-Reset helps vor a Moment, but after Restart, i habe no signal.

I had this same issue on my ASA 5520.

1. Copy the config and IOS image to a tftp server.
2. Format flash (disk0)
3. set rommon server, ip addy, and file settings.
4. tftpdnld
5. Once the system has booted to the image copy the asa image file, asdm image file, and config to flash
6. configure asdm image default location and reload