Pioneer tv I have a pioneer projection tv model # SD-P55A3-K I have sound but no picture

The problem is on lamp try to replace it to get back the picture..

Sounds like you got a bad connection, that has finally come off.

Moving those big things can cause that.

Open the back and check.

And call an expert.

If ya in VB, I'll do it.

PLEASE RATE THIS ANSWER

No,don't this tv is a delicate equipments inside.Tv CRTS R,G,B TUBES guns are easily to be broken if dosen't have the outer frame to protect it.Also the Tv CRTS R,G,B TUBES guns have coolant chemicals inside it,could also damage ur tv even if the CRTS R,G,B TUBES guns are not broken.Tries to put it on the cargo pallet,put a heavy blanket on.Ties it with a heavy ropes tightly and firmly.Than put it in a moving Rider truck or a personal truck.Now firmly sacures the tv for good not to make any movment.Now u can tranport it anywhere.

probably the solder connections on the convergence board.. solder it up good and it will usually stop blowing that fuse..
what is the fuse #?

let me know if i can be of further asistance

Th convergance amps have failed you will half to replace them, or have it done parts are around 70 dollars not and easy fix on a pioneer time consuming

It ur convergence it dead,know how to solders?Tries these websites for convergence kits.Tv repair World.com Tv repair kits.

I suggest you do a technical review porq you may worsen your situation

These sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the picture to look normal. When its out of alignment the video will look 3-D, wavy, distorted, etc. Most of the time you just need to adjust your convergence in the menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.

Convergence problems are very common on all Projection TV sets including Sony,Samsung, JVC, Philip Magnavox, Panasonic, Akai, Pioneer, Hitachi, Zenith, and others. You can get a convergenece repair kit wiith instructions from the links below.

Here are some of the most common problems with these sets...

Problem #1) Convergence

Yours may have one or more of the following symptoms

• Screen Looks 3-D
• Colors wont align
• Screen may look distorted or warped
• No Audio/Video - makes a chirping sound.

Problem #2

Another common problem is dull or washed out video.
Your TV may have one or more of the following symptoms....

• Dull looking picture
• White looking picture
• Halos around objects
• Red/Orange looking picture

You can see some more examples and find a fix here
http://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

call someone out to reconverge it for you it shouldnt cost alot and it will get the picture right again

This sounds like a picture mode issue. You maybe in a ZOOM mode. Try adjusting your set to FULL mode. If you are using a Sat receiver or cable box, some of these may have picture viewing mode as well, wich may need to be set in FULL or NORMAL viewing mode.

Good Luck!