I have a Krups Nespresso System,Automatic, Type 554, but the manual is lost. More numbers on the bottom of the machine: Q95256 , 23097H, N78 I hope you can help me to get a manual.

Here you go...good luck! :) http://kitchen.manualsonline.com/manuals/mfg/nespresso/c290_d290.html

For Nespresso C250, you can look up Krups 554 or 580 and I found this manual http://safemanuals.com/user-guide-instructions-owner-manual/KRUPS/NESPRESSO-PROGRAMATIC-554-_E for download. I'm pretty sure this is the one!

best bet is on-line

Use less water....

This machine does not have that muck electronic, the button switch has probably a short, and must be replaced.

As said the machine is Krups, and therefore should be covered with one year warranty. Call the number listed on the user manual, or find contact from websites below:

Coffee & Espresso Machines - Small Domestic Appliances - Krups

Home - Krups UK

That sounds like a faulty switch. This machine has one year factory warranty from Krups.

Contact the phone number listed on the user manual, or check on Krups website.

Coffee & Espresso Machines - Small Domestic Appliances - Krups

Home - Krups UK

Dear,

My wive bought a new nesspresso machine.
I will keep my old machine for repair parts for my mother, she has simullar machine.

greetings

just wanted to comment on the issue with the Aeroccino when it stops working. As has been mentioned, Nespresso stated in the past that perhaps moisture (water) had gotten into the bottom of the frother and that might have been the reason it had stoped working. This was not my problem---I was very diligent in preventing ANY moisture entering the unit. But Nespresso has finally acknowledged the real issue. This is Nespresso's partial reply to my query: "Another possible cause for the Aeroccino to not turn on is the result of the Aeroccino jug being stored on the Base. The base does not have an on/off switch; therefore it is drawing full power at all times when plugged-in. If the Aeroccino jug is stored on a plugged-in base it can short-circuit. Once this has occurred there is no troubleshooting that will alleviate the issue, and replacement is the only option." There you have it. Mine would turn on for a several seconds, and merely warm the milk, instead of frothing it. I guess it took us 9 months to short-circuit it. Luckily ours is still under warranty, so a replacement is being shipped. Good luck to all of you with the same problem...I hope you are still under warranty. For those of you with a working Aeroccino: Don't leave the base plugged-in when not using the unit.

both parts can be found on amazon for about 9.99$. take a look here: Secura Automatic Electric Milk Frother and Warmer Whisk Set. I hope this was helpful. cheers

I had the same problem with the nespresso krups xn20 machine. After calling the Nespresso service desk they substituted free of charge the water tank, which has a little valve with seal at the bottom. It turned out that the problem was not the seal of the water tank, but the seal of the machine (onto which the water tank is installed).
I solved the problem by using Teflon tape (same type as that used to connect for water pipes) on the water tank, applying it at the appendix which goes into the machine.
It's been working ok since then (couple of days). The only problem could be the wearing-off of the tape after some time (you will have to reapply it).