My krups coffee machine comes up with service 8, what does this mean

you can only remove the capsule from the capsule holder by means of piercing from under were coffee normally comes out .that is not to say that if the Circolo is not auto.
if the machine is auto then it may be that the director motor or gear of director motor is slipt or broken

Contact the manufacturer by phone, or use the online method to ask for help:

If you have a question about a Krups product, please select "Consumer Service" as the theme of your request or contact us at 1-800-526-5377 (Monday to Friday 8:00am to 6:00pm EST)


https://www.krupsusa.com/consumer-services/Contact-us

Error 6 means machine thinks it has a leak in one or more of the following
1) Distributor
2) Thermoblock
3) Pump valve
4) Pipe leakage
Repair will involve specialised tools and parts, not really the sort of job to attempt yourself. Contact Krups and get from them contact information for your local service agent.

I think that error code means it needs a new motor driving unit for the brewing unit. Tell me what it does in detail when you attempt to make a coffee. [email protected]

Would you like to try not put too much coffee powder, and not make the coffee powder too firm ( I mean not press them too heavy.)

Or, not grind the coffee powder too thin....

Hope it helps you.

Error code 07 on my Krups XP 7220 coffee machine what to do? Nick

On mine, the coffee dispenser had become stuck or clogged with ground coffee. cleaning this and giving it a bit of assistance on the next power up solved the problem. you will need to remove the two TX-15 torx screws at the front under the coffee flap/lid and the water flap/lid. there are also four screws down the back which dont have any screw driver slots in them. you will need a pair of vice grips or similar pliers to undo them. The top then lifts off and you can see down the coffee dispenser enough to clean it out. If you intend to test it with the lid off you will need to tape a magnet on the gray reed switch at the top (to simulate the ground coffee lid being closed). Obviously if you remove the two last screws at the bottom back you can easily remove the sides however in my case this wasn't necessary.

that mean no coffee go through us if you dont use the machine often you might have coffee residue on the grinder teet remove the coffee bean in the hole were the coffee bean goes use a brush and clean the grinder teet very good with the residue of coffee gonna grind and gonna go through thanks for usig fixya pierre

The grinder needs to be either replaced or at least repaired.

The krups website does have a listing for where to send in for service in China,. That website is www.krupsusa.com