I have a universal remote that has RC 430 and was made n china. That is all that is on the remote. The tv is a symphonic, the remote control does not have a tv button on it. Only enter, code search, sleep

Francisco Mauricio G

• 1551 Answers
• Posted on Jun 02, 2009

SOURCE: No remote, need code for universal remote

Try this method:
Turn on the device you want to program.
Press and hold CODE SEARCH until the indicator light lights then release code search.
Press and release the device button you are programing TV, the indicator light will blink once then remain lit.
Press and release OFF/ON until your device turn off.
you may have to press upto 200 times
When your device turn off press enter button the indicator light will go off,good luck.

SOURCE: Remote randomly works. 27" Symphonic TV... but remote works on other Symphonics in the house

I have the same TV & problem.
The problem is Not with the remote but with the remote receiving circuit in the TV. The remote works once in a while.
Anyone have the TV schematic diagram?

SOURCE: forgotten code

the code is026.

SOURCE: I have a WF20D4 TV and a comcast universal remote. I can not find the code that turns my tv on and controls volume for my comcast remote. I lost the TV remote.

0180, 0171, 0000 if your remote has a GREY ok/select button on it,
20675, 20821, 20000, 20593, 21593 if your remote has a RED ok/select button on it

Joe Negus

• 652 Answers
• Posted on Jun 30, 2010

SOURCE: Need remote code

Programming a Living Solutions Universal Remote
1. Step 1 Turn on the component you wish to sync to your universal remote--your television, DVD player, VCR or stereo.
   
2. Step 2 Point the remote at the device you are programming and press the corresponding device button on the remote. These buttons are labeled "TV," "VCR", "DVD," etc. Hold the device button for three to five seconds.
   
3. Step 3 Push the power button on the remote. This should turn on the device that you are syncing.
   
4. Step 4 Push the "Channel Up" or "Channel Down" button on your remote gradually until the device that you are programming shuts off.
   
5. Step 5 Press "OK" or "Enter" on the remote once the synced device turns off.
   
6. Step 6 Press the device button for the component you just programmed, and hit the power button while pointing the remote at the component. If programmed correctly, the device should turn on, and you should be able to control it with your Living Solutions Universal Remote.