My Kenmore Elite washer model 110.27062600 stopped working. All the front panel lights are flashing on and off for 7 times then pauses and starts blinking again. The machine will not do anything. No response to pushing any buttons. Tried unplugging for a period of time when plugged back in it goes through the same blinking panel lights and still will not respond.

SOURCE: Control Panel

I believe the DRAIN/SPIN button on the Kenmore Elite HE3 will clear a locked control panel if you hold the button in for 3 seconds. This is actually a safety feature to keep small children from playing with the buttons and allows the consumer to lock the control panel. I hope that's all the problem you have and that it is not a control panel failure. Let me know if this helps. PS The matching Kenmore Elite Dryer uses the AUTO DRY LEVEL button for the same feature.

SOURCE: KENMORE ELITE MODLE 110 20082 992

We have the 11020092991, same washer. Ours has had all kinds of problems. We kept renewing our extended warranty and finally in August 2007, Sears concurred and called it a lemon and gave us credit for a new washer.

SOURCE: Control Panel

I have encountered the same problem and now I can use my washer again. Yay!!

Thank you.

SOURCE: F2 error code on my Kenmore Elite HE3 washer

Based upon your description, the drain pump has either failed or the pump filter has become clogged.
To check the pump, remove the bottom access panel. There you will find access to the pump clean-out.(Large,white screw cap) BE READY TO CATCH LOTS OF WATER. CAREFULLY AND S_L_O_W_L_Y unscrew the pump clean-out, catching and discarding the water. When the water flow finally stops, completely remove the clean-out filter. Inspect the clean-out filter, the drain hose from the tub as well as inside the pump impeller for any additional debris.

If you need further assistance, let me know
Regards,
reg501

SOURCE: F2 error code on my Kenmore Elite HE3 washer

Had this problem on our Kenmore machine.

This is what done.

1. Unplug the washer

2. Take of the toe panel in the front by removing the three screws.

3. Get a bunch of towels (I mean a bunch!!!)

4. The pump is in the center, and it has a plastic grip handle that one can unscrew to remove the filter. As you unscrew it, LOTS of water will come out. Be ready with the towels. A cookie sheet helps to collect the water too.

5. Clean the filter assembly.

6. If one wishes to check the inlet of the pump, remove the back panel, about 12 screws. (Note, the following works for replace the pump as well)

7. Remove the large bellow from the bottom of the tub that goets to inlet of the pump by removing the clamp

9. Lift up on the plastic cover that covers the wires that power the pump. There may be a small plastic catch that is lifted up as to allow the connector to become free.

8. Remove the Torx screw that holds that is the center just under the filter screen.

9. Pull the pump forward.

10. Unclamp the pump outlet hose.

11. Remove pump

12. Unclamp the large bellow on the pumps inlet and inspect for debris.

13. Clean pump and fitler w/o getting water on the pump.

14. Install in reverse order. Remember, it is much easire to put the inlet bellow and outlet hose on the pump before you put into the washer